Simulating the Multistage Environment for Single-Stage Compressor Experiments
Authors:
- 1 October 1996
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 118 (4) , 706-716
Abstract
The performance of a single-stage low-speed compressor has been measured both before and after the introduction of certain features of the multistage flow environment. The aim is to make the single-stage rig more appropriate for developing design rules for multistage compressors. End-wall blockage was generated by teeth on the hub and casing upstream of the rotor. A grid fitted upstream produced free-stream turbulence at rotor inlet typical of multistage machines and raised stage efficiency by 1.8 percent at the design point. The potential field that would be generated by blade rows downstream of an embedded stage was replicated by introducing a pressure loss screen at stage exit. This reduced the stator hub corner separation and increased the rotor pressure rise at flow rates below design, changing the shape of the pressure-rise characteristic markedly. These results highlight the importance of features of the flow environment that are often omitted from single-stage experiments and offer improved understanding of stage aerodynamics.Keywords
This publication has 7 references indexed in Scilit:
- Turbulence Intensity and Length Scale Measurements in Multistage CompressorsJournal of Turbomachinery, 1995
- Closure to “Discussion of ‘Endwall Effects at Two Tip Clearances in a Multistage Axial Flow Compressor With Controlled Diffusion Blading’” (1994, ASME J. Turbomach., 116, pp. 645–646)Journal of Turbomachinery, 1994
- Three-Dimensional Flow and Mixing in an Axial Flow Compressor With Different Rotor Tip ClearancesJournal of Turbomachinery, 1992
- Mixing in Axial Flow Compressors: Part II—Measurements in a Single-Stage Compressor and a DuctJournal of Turbomachinery, 1991
- Stall Inception in Axial Compressors1989
- Effect of the Inlet Velocity Profile in the Three-Dimensional Flow in a Rear Axial Compressor StageJournal of Turbomachinery, 1988
- Experimental Study of Three-Dimensional Flow in an Axial Compressor Stage1986