Dynamic mechanical analysis (DMA) of waterlogged archaeological wood at room temperature
Authors:
- 19 January 2018
- journal article
- research article
- Published by Walter de Gruyter GmbH in Holzforschung
- Vol. 72 (5) , 421-431
Abstract
The viscoelastic properties of waterlogged wood (WLW) were investigated via dynamic mechanical analysis (DMA) at room temperature and under water saturated conditions, aiming at the investigation of the relationships between viscoelasticity and chemical composition. Different softwoods (SWs) and hardwoods (HWs) from several archaeological sites were sampled, which had different levels of decay (from highly-decayed to little changed). The analytical methods included lignin and holocellulose determination by Fourier transform infrared (FTIR) spectroscopy, moisture content (MC), basic density (BD), micromorphological observations, and the DMA was performed in three-point bending and submersion mode. Both HWs and SWs showed an exponential decrease of both storage modulus (E′) and loss modulus (E″), which are related to the amount of crystalline and paracrystalline cellulose left in the cell wall, respectively. The ratio E″/E′ (tanδ) varied with the frequency in different ways depending on the preservation state of the samples. Less decayed material had a higher tanδ than the fresh reference wood and lower (or similar) tanδ in the case of highly decayed samples. Accordingly, the long-term behaviour under a certain sustained load of WLW is decay dependent.Keywords
This publication has 48 references indexed in Scilit:
- Reasoned use of chemical parameters for the diagnostic evaluation of the state of preservation of waterlogged archaeological woodJournal of Archaeological Science, 2013
- Wooden foundation piles and its underestimated relevance for cultural heritageJournal of Cultural Heritage, 2012
- On the long-term visco-elastic behaviour of polyethylene glycol (PEG) impregnated archaeological oak woodHolzforschung, 2010
- Influence of Frequency on Wood Viscoelasticity under Two Types of Heating ConditionsDrying Technology, 2010
- Orientation of the wood polymers in the cell wall of spruce wood fibresHolzforschung, 2009
- Micromechanics of creep and relaxation of wood. A review COST Action E35 2004–2008: Wood machining – micromechanics and fractureHolzforschung, 2008
- Cell wall features with regard to mechanical performance. A review COST Action E35 2004–2008: Wood machining – micromechanics and fractureHolzforschung, 2008
- DETERIORATION ASSESSMENT OF WATERLOGGED ARCHAEOLOGICAL LIGNOCELLULOSIC MATERIAL VIA 13C CP/MAS NMR*Archaeometry, 2007
- Relaxation behaviour of the amorphous components of woodJournal of Materials Science, 1987
- Viscoelastic properties ofin situ lignin under water-saturated conditionsJournal of Materials Science, 1984