Design, realization and testing of micro-mechanical resonators in thick-film silicon technology with postprocess electrode-to-resonator gap reduction
- 10 December 2002
- journal article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 13 (1) , 134-140
Abstract
This paper presents the design, fabrication and test of high-Q high-frequency lateral-mode clamped-clamped beam micro-resonators driven by parallel-plate electrostatic transducers fabricated in a thick epipoly technology. An innovative approach is employed to reduce an intrinsically high transducer gap value (>3.0 µm) required by the need of 15 µ mt hick structural layer etching down to 0.2-0.4 µ ma fter the fabrication. This is achieved by employing an electrostatic motor that approaches the actuating and sensing electrodes close to the resonator. The electrode motor is driven with 30 V dc voltage, without any dc current consumption. Two resonators having a resonance frequency of 10 MHz have been fabricated with gap values of respectively 0.2 and 0.4 µm. A comparative analysis of performances of the two resonators is given in the paper.Keywords
This publication has 5 references indexed in Scilit:
- High-Q HF microelectromechanical filtersIEEE Journal of Solid-State Circuits, 2000
- Dry Etching of Deep Si Trenches for Released Resonators in a Cl2 PlasmaJournal of the Electrochemical Society, 1998
- Polysilicon integrated microsystems: technologies and applicationsSensors and Actuators A: Physical, 1996
- Electrostatically driven vacuum-encapsulated polysilicon resonators Part I. Design and fabricationSensors and Actuators A: Physical, 1994
- Laterally Driven Polysilicon Resonant MicrostructuresSensors and Actuators, 1989