Titanium Dioxide Nanoparticles in Food and Personal Care Products
Top Cited Papers
- 18 January 2012
- journal article
- research article
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 46 (4) , 2242-2250
Abstract
Titanium dioxide is a common additive in many food, personal care, and other consumer products used by people, which after use can enter the sewage system and, subsequently, enter the environment as treated effluent discharged to surface waters or biosolids applied to agricultural land, incinerated wastes, or landfill solids. This study quantifies the amount of titanium in common food products, derives estimates of human exposure to dietary (nano-) TiO2, and discusses the impact of the nanoscale fraction of TiO2 entering the environment. The foods with the highest content of TiO2 included candies, sweets, and chewing gums. Among personal care products, toothpastes and select sunscreens contained 1% to >10% titanium by weight. While some other crèmes contained titanium, despite being colored white, most shampoos, deodorants, and shaving creams contained the lowest levels of titanium (2 (E171) suggests that approximately 36% of the particles are less than 100 nm in at least one dimension and that it readily disperses in water as fairly stable colloids. However, filtration of water solubilized consumer products and personal care products indicated that less than 5% of the titanium was able to pass through 0.45 or 0.7 μm pores. Two white paints contained 110 μg Ti/mg while three sealants (i.e., prime coat paint) contained less titanium (25 to 40 μg Ti/mg). This research showed that, while many white-colored products contained titanium, it was not a prerequisite. Although several of these product classes contained low amounts of titanium, their widespread use and disposal down the drain and eventually to wastewater treatment plants (WWTPs) deserves attention. A Monte Carlo human exposure analysis to TiO2 through foods identified children as having the highest exposures because TiO2 content of sweets is higher than other food products and that a typical exposure for a US adult may be on the order of 1 mg Ti per kilogram body weight per day. Thus, because of the millions of tons of titanium-based white pigment used annually, testing should focus on food-grade TiO2 (E171) rather than that adopted in many environmental health and safety tests (i.e., P25), which is used in much lower amounts in products less likely to enter the environment (e.g., catalyst supports, photocatalytic coatings).Keywords
This publication has 38 references indexed in Scilit:
- TiO2-based nanoparticles released in water from commercialized sunscreens in a life-cycle perspective: Structures and quantitiesEnvironmental Pollution, 2011
- Occurrence and removal of titanium at full scale wastewater treatment plants: implications for TiO2 nanomaterialsJournal of Environmental Monitoring, 2011
- The release of engineered nanomaterials to the environmentJournal of Environmental Monitoring, 2011
- Ecotoxicity of nanosized TiO2. Review of in vivo dataEnvironmental Pollution, 2011
- Aging of TiO2 nanocomposites used in sunscreen. Dispersion and fate of the degradation products in aqueous environmentEnvironmental Pollution, 2010
- Testing Metal‐Oxide Nanomaterials for Human SafetyAdvanced Materials, 2010
- Lung exposure to nanoparticles modulates an asthmatic response in a mouse modelEuropean Respiratory Journal, 2010
- Nanotechnology, nanotoxicology, and neuroscienceProgress in Neurobiology, 2009
- Synthesis of TiO2 nanoparticles by hydrolysis and peptization of titanium isopropoxide solutionJournal of Materials Processing Technology, 2007
- Validation of an inductively coupled plasma mass spectrometry (ICP-MS) method for the determination of cerium, strontium, and titanium in ceramic materials used in radiological dispersal devices (RDDs)Analytica Chimica Acta, 2007