Ultra Fast and Parsimonious Materials Screening for Polymer Solar Cells Using Differentially Pumped Slot-Die Coating
- 29 September 2010
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 2 (10) , 2819-2827
Abstract
We present a technique that enables the probing of the entire parameter space for each parameter with good statistics through a simple roll-to-roll processing method where gradients of donor, acceptor, and solvent are applied by differentially pumped slot-die coating. We thus demonstrate how the optimum donor−acceptor ratio and device film thickness can be determined with improved accuracy by varying the composition in small steps. We give as an example P3HT-PCBM devices and vary the composition between P3HT and PCBM in steps of 0.5−1% giving 100−200 individual solar cells. The coating experiment itself takes less than 4−8 min and requires 15−30 mg each of donor and acceptor material. The optimum donor−acceptor composition of P3HT and PCBM was found to be a broad maximum centered on a 1:1 ratio. We demonstrate how the optimal thickness of the active layer can be found by the same method and materials usage by variation of the layer thickness in small steps of 1.5−4 nm. Contrary to expectation we did not find oscillatory variation of the device performance with device thickness because of optical interference. We ascribe this to the nature of the solar cell type explored in this example that employs nonreflective or semitransparent printed electrodes. We further found that very thick active layers on the order of 1 μm can be prepared without loss in performance and estimate the active layer thickness could easily approach 4−5 μm while maintaining photovoltaic properties.Keywords
This publication has 16 references indexed in Scilit:
- Polymer solar cell modules prepared using roll-to-roll methods: Knife-over-edge coating, slot-die coating and screen printingSolar Energy Materials and Solar Cells, 2009
- Fabrication and processing of polymer solar cells: A review of printing and coating techniquesSolar Energy Materials and Solar Cells, 2009
- Binary Organic Photovoltaic Blends: A Simple Rationale for Optimum CompositionsAdvanced Materials, 2008
- High throughput testing platform for organic Solar CellsProgress in Photovoltaics: Research and Applications, 2008
- Processing Additives for Improved Efficiency from Bulk Heterojunction Solar CellsJournal of the American Chemical Society, 2008
- Electronic memory effects in diodes of zinc oxide nanoparticles in a matrix of polystyrene or poly(3-hexylthiophene)Journal of Applied Physics, 2007
- Efficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiolsNature Materials, 2007
- Efficiency limiting factors of organic bulk heterojunction solar cells identified by electrical impedance spectroscopySolar Energy Materials and Solar Cells, 2007
- High-efficiency solution processable polymer photovoltaic cells by self-organization of polymer blendsNature Materials, 2005
- Highly Conductive and Transparent Aluminum Doped Zinc Oxide Thin Films Prepared by RF Magnetron SputteringJapanese Journal of Applied Physics, 1984