Joint Strength Optimization of Adhesively Bonded Patches
- 19 November 2008
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 84 (11) , 915-934
Abstract
Aircraft face damage from impact with objects or birds or due to ageing that leads to fatigue cracks. The conventional methods of repairing aircraft metallic structures generally include the use of a plate joined by screws or rivets. Although these methods are efficient in the short term, they introduce stress concentrations leading to the initiation of new cracks that are difficult or impossible to detect by non-destructive methods. For these reasons, it is necessary to develop new methods to improve the behaviour of the structure (especially for long term) and its manufacture cost. One of the solutions that have been studied by the aeronautical industry is the use of patches bonded with structural adhesives. However, adhesively bonded patches have problems of stress concentration at the edges where crack initiation is prone to occur. This problem can be reduced by the use of a taper and a spew fillet at the end of the patch and by the use of a mixed adhesive technique where a ductile adhesive is placed at the edges of the patch. Double strap specimens from 3 mm thick 6063-T6 aluminium alloy sheet were analysed. Aluminium and straps (or patches) with an internal taper, an adhesive spew fillet, and dual adhesives were experimentally tested. The results obtained were explained by a finite element analysis. A taper angle is beneficial only for the brittle adhesive. The use of two adhesives is advantageous for the taperless configuration.Keywords
This publication has 22 references indexed in Scilit:
- Adhesively bonded lap joints from pultruded GFRP profiles. Part III: Effects of chamfersComposites Part B: Engineering, 2006
- Impact behaviour of bonded built-up beams: experimental resultsInternational Journal of Adhesion and Adhesives, 2005
- Increasing strength of single lap joints of metal adherends by taper minimizationJournal of Adhesion Science and Technology, 2003
- Through-thickness shape optimisation of bonded repairs and lap-jointsInternational Journal of Adhesion and Adhesives, 2002
- Understanding and control of adhesive crack propagation in bonded joints between carbon fibre composite adherends II. Finite element analysisInternational Journal of Adhesion and Adhesives, 2001
- Strength prediction of patch-repaired CFRP laminates loaded in compressionComposites Science and Technology, 2000
- Shape optimisation of adhesive filletsInternational Journal of Adhesion and Adhesives, 2000
- Non-linear analysis and optimization of adhesively bonded single lap joints between fibre-reinforced plastics and metalsInternational Journal of Adhesion and Adhesives, 1994
- A simple stress analysis method for adhesive bonded tapered jointsInternational Journal of Adhesion and Adhesives, 1989
- Stress Analysis and Failure Properties of Carbon-Fibre-Reinforced-Plastic/Steel Double-Lap JointsThe Journal of Adhesion, 1986