Breath sensor based on conductive foam: Idea, construction, and characterisation
- 20 October 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 219-224
Abstract
This paper deals with breath sensor constructed based on conductive, polyurethane foam, which is usually used for storage of electronics devices. A piece of the foam with especially prepared terminals is placed under tight T-shirt at the chest of a monitored person. The paper presents the idea of the sensor, investigation on its construction and problems being faced with. Parameters assessment processes and results are described too, so finally well characterized electronics component, ready to use, is presented. Some examples of use of the sensor are presented at the end of the paper.Keywords
This publication has 7 references indexed in Scilit:
- Low-cost portable respiration monitor based on micro hot-film flow sensor2010
- A Visual Context-Awareness-Based Sleeping-Respiration Measurement SystemIEEE Transactions on Information Technology in Biomedicine, 2009
- Textile-Based Capacitive Sensors for Respiration MonitoringIEEE Sensors Journal, 2008
- Analysis of Respiratory Sounds: State of the ArtClinical medicine. Circulatory, respiratory and pulmonary medicine, 2008
- A respiration monitor based on electrocardiographic and photoplethysmographic sensor fusion2018 40th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC), 2007
- A Wearable Textile for Monitoring Respiration, Using a Yarn-Based Sensor2006 10th IEEE International Symposium on Wearable Computers, 2006
- A method for respiration monitoring by the use of a bioacoustic signal2000