Simulation of screw connected built-up cold-formed steel back-to-back lipped channels under axial compression
Authors:
- Smail KechidiSKSmail Kechidi
- David C. FratamicoDFDavid C. Fratamico
- Benjamin W. SchaferBSBenjamin W. Schafer
- José Miguel CastroJosé Miguel Castro
- Nouredine BourahlaNBNouredine Bourahla
- 1 March 2020
- journal article
- research article
- Published by Elsevier in Engineering Structures
- Vol. 206
Abstract
No abstract availableKeywords
Funding Information
- U.S. Department of War (NDSEG)
- National Defense Science and Engineering Graduate (NDSEG)
- Air Force Office of Scientific Research (NDSEG)
This publication has 23 references indexed in Scilit:
- Ultimate load-carrying capacity of cold-formed thin-walled columns with built-up box and I section under axial compressionThin-Walled Structures, 2014
- Development of an Axial Load Capacity Equation for Doubly Symmetric Built-Up Cold-Formed SectionsJournal of Structural Engineering, 2013
- Numerical study of built-up double-Z members in bending and compressionThin-Walled Structures, 2012
- Simulation of geometric imperfections in cold-formed steel members using spectral representation approachThin-Walled Structures, 2012
- Experimental investigation concerning lipped channel columns undergoing local–distortional–global buckling mode interactionThin-Walled Structures, 2012
- Experimental investigation of built-up double-Z members in bending and compressionThin-Walled Structures, 2012
- Evaluation of the slenderness ratio in built-up cold-formed box sectionsJournal of Constructional Steel Research, 2011
- Computational modeling of cold-formed steelThin-Walled Structures, 2010
- Simulation of cold-formed steel beams in local and distortional buckling with applications to the direct strength methodJournal of Constructional Steel Research, 2007
- Behavior of cold-formed steel built-up I-sectionsThin-Walled Structures, 2005