A low temperature bonding of quartz microfluidic chip for serum lipoproteins analysis
- 23 June 2006
- journal article
- Published by Springer Nature in Biomedical Microdevices
- Vol. 8 (3) , 255-261
Abstract
A low-temperature bonding method for microfabrication of quartz microfluidic chips has been developed. The bonding process involved two steps: pre-bonding and post-annealing at low temperature. The bonding quality was evaluated by measuring the shear force at bonding interface and the electrical properties of the chips. Shear force of 5.66 MPa (566 N/cm2) was obtained in a bonded chip after a post-annealing at 200∘C for 6 h. We owe the strong bonding strength to the formation of Si–O–Si bonds at the bonding interface during the post-annealing stage. The bonding procedures were not sensitive to surrounding and could be performed in a routine laboratory without clean room conditions. The performance of the fabricated microfluidic chips was tested by capillary zone electrophoresis (CZE) of serum lipoproteins with laser-induced fluorescence (LIF). The low-density (LDL) and high-density (HDL) lipoproteins in the serum was separated completely by using tricine buffer with methylglucamine.Keywords
This publication has 28 references indexed in Scilit:
- Isoelectric focusing in cyclic olefin copolymer microfluidic channels coated by polyacrylamide using a UV photografting methodElectrophoresis, 2005
- Analysis of Passive Mixing Behavior in a Poly(Dimethylsiloxane) Microfluidic Channel Using Confocal Fluorescence and Raman MicroscopyApplied Spectroscopy, 2004
- DNA Mutation Detection in a Polymer Microfluidic Network Using Temperature Gradient Gel ElectrophoresisAnalytical Chemistry, 2004
- Poly(dimethylsiloxane)‐based microfluidic device with electrospray ionization‐mass spectrometry interface for protein identificationElectrophoresis, 2003
- Fabrication and characterization of poly(methyl methacrylate) microchannels by in situ polymerization with a novel metal templateElectrophoresis, 2003
- Surface-chemistry technology for microfluidicsJournal of Micromechanics and Microengineering, 2003
- Water glass bonding for micro-total analysis systemSensors and Actuators B: Chemical, 2002
- Microfluidic systems with on-line UV detection fabricated in photodefinable epoxyJournal of Micromechanics and Microengineering, 2001
- Electroosmotic Pumping and Valveless Control of Fluid Flow within a Manifold of Capillaries on a Glass ChipAnalytical Chemistry, 1994
- Low temperature wafer direct bondingJournal of Microelectromechanical Systems, 1994