Evaluation of induced trench twin culverts constructed in deep fill
Authors:
- 1 September 2020
- journal article
- research article
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 57 (9) , 1388-1403
Abstract
When culverts are installed beneath high embankments, earth loads become excessive and the induced trench construction method is a viable design option to reduce the culvert loads to acceptable levels. However, limited field studies evaluating the performance of induced trench twin culverts are reported in the literature and the practicality and effectiveness of the induced trench construction method (in general) has been subject to recent criticism. This paper describes the performance of twin 3048 mm inside-diameter reinforced concrete culverts constructed with an induced trench beneath 15.3 m of fill. Research instruments and autonomous data acquisition systems were installed during construction to monitor (i) culvert earth pressures, (ii) embankment deformations, and (iii) groundwater elevations in the vicinity of the compressible fill. The experimental observations recorded throughout the construction phase are presented herein; the embankment deformations are indicative of effective positive arching within the induced trench region, and the average earth pressure at the culvert crown was reduced to approximately 48% of the overburden soil pressure. The experimental data are compared with those reported in the literature by others, and the conclusions attained from this study demonstrate the effectiveness of the induced trench construction method.Keywords
This publication has 22 references indexed in Scilit:
- Field monitoring and analysis of twin 3660 mm inside diameter induced trench culverts installed under 21.7 m of fillCanadian Geotechnical Journal, 2011
- Earth pressures on twin positive projecting and induced trench box culverts under high embankmentsCanadian Geotechnical Journal, 2011
- Field performance, centrifuge testing, and numerical modelling of an induced trench installationCanadian Geotechnical Journal, 2008
- Field Performance and Analysis of 3-m-Diameter Induced Trench Culvert under a 19.4-m Soil CoverTransportation Research Record: Journal of the Transportation Research Board, 2008
- Effects of frictional forces acting on sidewalls of buried box culvertsInternational Journal for Numerical and Analytical Methods in Geomechanics, 2007
- Design Loading on Deeply Buried Box CulvertsJournal of Geotechnical and Geoenvironmental Engineering, 2005
- Anatomy of an ErrorJournal of Geotechnical and Geoenvironmental Engineering, 2004
- Geotechnical Properties of Compressible Materials Used for Induced Trench ConstructionJournal of Testing and Evaluation, 2004
- Reappraisal of Marston’s FormulaJournal of Transportation Engineering, 2003
- The induced trench method—a critical review and case historyCanadian Geotechnical Journal, 1988