Reduction of Liquid Bridge Force for 3D Microstructure Measurements
Open Access
- 16 May 2016
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 6 (5) , 153
Abstract
Recent years have witnessed an increased demand for a method for precise measurement of the microstructures of mechanical microparts, microelectromechanical systems, micromolds, optical devices, microholes, etc. This paper presents a measurement system for three-dimensional (3D) microstructures that use an optical fiber probe. This probe consists of a stylus shaft with a diameter of 2.5 µm and a glass ball with a diameter of 5 µm attached to the stylus tip. In this study, the measurement system, placed in a vacuum vessel, is constructed suitably to prevent adhesion of the stylus tip to the measured surface caused by the surface force resulting from the van der Waals force, electrostatic force, and liquid bridge force. First, these surface forces are analyzed with the aim of investigating the causes of adhesion. Subsequently, the effects of pressure inside the vacuum vessel on surface forces are evaluated. As a result, it is found that the surface force is 0.13 µN when the pressure inside the vacuum vessel is 350 Pa. This effect is equivalent to a 60% reduction in the surface force in the atmosphere.Keywords
This publication has 16 references indexed in Scilit:
- New concept of a 3D-probing system for micro-componentsCIRP Annals, 2010
- Development of a System for Measuring Micro Hole Accuracy Using an Optical Fiber ProbeJournal of Advanced Mechanical Design, Systems, and Manufacturing, 2010
- A vibrating micro-scale CMM probe for measuring high aspect ratio structuresMicrosystem Technologies, 2009
- Study of a micro-roughness probe with ultrasonic sensorCIRP Annals, 2008
- Development of the nano-probe system based on the laser-trapping techniqueCIRP Annals, 2008
- Fiber deflection probe for small hole metrologyPrecision Engineering, 2006
- Development of a virtual probe tip with an application to high aspect ratio microscale featuresReview of Scientific Instruments, 2005
- Development of Measuring Method for Shape and Dimension of Micro-components. Modification to the Original Measuring System, Calibration of the Probes and the Results of Dimensional Measurements.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 2002
- Opto-tactile Sensor for 2D and 3D Measurement of Small Structures on Coordinate Measuring MachinesCIRP Annals, 2001
- Vibroscanning Method for Nondestructive Measurement of Small HolesCIRP Annals, 1993