Optimizing light-cured composite through variations in camphorquinone and butylhydroxytoluene concentrations
Authors:
Open Access
- 1 January 2016
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Brazilian Oral Research
- Vol. 30 (1)
Abstract
The use of a free-radical polymerization inhibitor, butylhydroxytoluene (BHT), and a common photo-initiator, camphorquinone (CQ), to reduce polymerization stress in dental composite was investigated in this study. Samples were prepared by mixing Bis-GMA, UDMA, and TEGDMA at a 1:1:1 ratio (wt%), and silanized borosilicate glass fillers at 70 wt% were added to form the composite. Sixteen groups of resin composite were prepared using combinations of four CQ (0.1%, 0.5%, 1.0%, and 1.5%) and four BHT (0.0%, 0.5%, 1.0%, and 1.5%) concentrations. For each group, six properties were tested, including flexural strength (FS), flexural modulus (FM), degree of conversion (DC), contraction stress (CS), stress rate, and gel point (GP). The effects of CQ and BHT combinations on each of these properties were evaluated using two-way analysis of variance (ANOVA) and Fisher's Protected Least Significant Differences test at the 5% significance level. Groups with low CQ and BHT showed moderate values for FS, FM, and CS with a 70% DC. Increasing the BHT concentration caused a decrease in CS and DC with an increase in GP values. Increasing the CQ content led to a steady increase in values for FS and FM. High CQ and BHT combinations showed the most promising values for mechanical properties with low stress values.Keywords
This publication has 19 references indexed in Scilit:
- Mapping camphorquinone consumption, conversion and mechanical properties in methacrylates with systematically varied CQ/amine compositionsDental Materials, 2014
- Redox initiator systems for emulsion polymerization of acrylatesJournal of Polymer Science Part A: Polymer Chemistry, 2009
- The effect of resin matrix composition on the polymerization shrinkage and rheological properties of experimental dental compositesDental Materials, 2007
- Factors involved in the development of polymerization shrinkage stress in resin-composites: A systematic reviewDental Materials, 2005
- Primary cyclization in the polymerization of bis-GMA and TEGDMA: a modeling approach to understanding the cure of dental resinsDental Materials, 2001
- Light initiation of dental resins: dynamics of the polymerizationBiomaterials, 1996
- Fracture Toughness of Experimental Dental Composites Aged in EthanolJournal of Dental Research, 1995
- Kinetic Gelation model predictions of crosslinked polymer network microstructureChemical Engineering Science, 1994
- Stiffness Increase During the Setting of Dental Composite ResinsJournal of Dental Research, 1987
- The effect of resin formulation on the degree of conversion and mechanical properties of dental restorative resinsJournal of Biomedical Materials Research, 1986