Fiber-Optic and Ultrasonic Measurements for In-Situ Cure Monitoring of Graphite/Epoxy Composites
Authors:
- J. -Y. ChenJCJ. -Y. Chen
- C. -K. JenCJC. -K. Jen
- 1 October 1999
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 33 (20) , 1860-1881
Abstract
To produce high-quality composites with high density and low void content, the knowledge of cure process is very important, and the sensors capable of monitoring the cure process are therefore desirable. Since the term of "fully processed" should be a reflection of the ultimate material application, the objectives of the present work are to monitor how material properties have been developed during the cure and justify when "end-of-cure" has been achieved by measuring chemical and mechanical properties of the curing composites. As a reference, differential scanning calorimetry is used to evaluate the degree of cure while fiber-optic sensors are used to measure the evolution of process-induced strains, and ultrasonic sensors are used to monitor the development of viscoelastic properties of the curing composites. Moreover, an ultrasonic cure monitoring system has been developed, by using conventional broadband ultrasonic sensors together with clad buffer rods. The major merits of this system can be summarized as (i) workable inside an autoclave at high temperature (for example, up to 2500C if by water-cooling) and internal pressure (for example, 100 psi); (ii) high signal to spurious ultrasonic noise ratio, and high signal strength; (iii) suitable for longitudinal or shear wave measurement in reflection/transmission mode.Keywords
This publication has 14 references indexed in Scilit:
- A Fiber Optic Ultrasonic System to Monitor the Cure of EpoxyResearch in Nondestructive Evaluation, 1997
- In-situ fiber optic sensor for composite cure monitoring through characterization of resin viscoelasticity1996
- Measurement of process-induced strains in composite materials using embedded fiber optic sensors1996
- Combined fiber optic strain sensor and composite cure monitor for smart structure applications1994
- In-situ sensors for intelligent process control for fabrication of polymer-matrix composite materials1994
- Real-time study of frequency dependence of attenuation and velocity of ultrasonic waves during the curing reaction of epoxy resinThe Journal of the Acoustical Society of America, 1986
- Autoclave moulding of carbon fibre-reinforced epoxiesComposites, 1986
- Heat of Reaction, Degree of Cure, and Viscosity of Hercules 3501-6 ResinJournal of Composite Materials, 1982
- Monitoring the moduli of polymers with ultrasoundJournal of Applied Physics, 1974
- A new tool for determination of the stage of polymerization of thermosetting polymersJournal of Polymer Science, 1952