Computerized modeling techniques have been developed for analysis of offshore cathodes protection (CP-) systems. Computer programs already developed and new programs under development include applications of the finite difference and the finite element methods. As opposed to traditional CP design methods, based on a few simple formulae and certain rules of thumb, these new methods allow for detailed analysis of potential and current distributions in nodes and other complex areas of the structures. Particularly this paper deals with application of such methods in analysis of survey data from North Sea structures. The programs have been used to analyze potential and current density readings, to estimate current output from sacrificial anodes, current consumption n exposed steel etc. This information is used in "diagnostics" of CP performance, to disclose problems and causes to unsatisfactory protection and to provide information for re-design of CP systems if required. INTRODUCTION.: During the last 4-5 years there has been a growing interest in development and application of computer programs for modeling of electrochemical systems including offshore cathodes protection (CP-) systems. This interest strongly relate to the increased activity worldwide in offshore drilling and production of oil and gas. Large offshore structures of increasing size and complexity have been installed in ever deeper waters, and in hostile environments like the North Sea. Unfortunately there is a large number of examples of unsatisfactory cathodes protection performance of such structures. These examples comprise problems which have appeared shortly after the structure was launched, as well as deficiencies developed over the first few years of operation and eventually created great needs for rectification. Included are hardware failures, e.g. of impressed current anode systems of unsatisfactory mechanical design to resist the loads of rough sea states. A considerable number, however, are simply caused by unsatisfactory CP design and anode distribution. Thus unfavorable changes in the potential(protective level) of the structures have been observed, often starting to appear at nodal areas on the structures, at risers, at well conductors or conductor guides and other complex and critical areas on the structures. It is obvious from this experience that large dimensions and structural complexity combined with high current density requirements for protection, represent a combination where the traditional CP design methods have proved inadequate. The traditional procedures have included the use of a set of formulae to estimate the current output from sacrificial anodes, and certain rules of thumb to distribute the anodes. Previous work has shown that the formulae used are inaccurate and may be estioned. Equally important is the fact that depolarization and shadow effects at such complex and critical areas as indicated above, are not accounted for1. Over the last few years various types of instruments have been employed increasingly in CP surveys of offshore structures. This include current density and electric field strength instrumentation, equipment for polarization tests etc. 2 ;3,4 This paper is particularly concerned with the application of computerized modeling/analysis of CP readings, comprising traditional CP potentials as well as readings obtained with the various instruments above. The objectives have often been to disclose problems and causes to unsatisfactory protection, and to provide information to be used in design of CP retrofit systems.