Sandwiched polyimide‐composite separator for lithium‐ion batteries via electrospinning and electrospraying
- 8 July 2020
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 41 (11) , 4478-4488
Abstract
A novel type of sandwiched separator for lithium‐ion batteries has been developed by combining electrospinning and electrospraying techniques. This separator consists of three layers in which the top and bottom layers are prepared by electrospinning a poly(amic acid) ammonium salt (PAAS) solution and the middle layer is obtained by electrospraying a mixture of the PAAS solution and inorganic nanoparticles (SiO2 or Al2O3). Subsequently, the sandwiched separators are imidized at 250°C in a nitrogen atmosphere. The morphology, porosity, thermal stability, mechanical strength, wettability and electrochemical performance of sandwiched separators were examined and the results were compared with those of a commercial separator (SV718). The thermal properties of the sandwiched separators and SV718 were determined using a thermal gravimetric analyzer and a differential scanning calorimeter. The sandwiched separators had no melting peak, whereas SV718 had a melting peak at 139°C, demonstrating the higher thermal stability of sandwiched separators. The electrolyte contact angles of sandwiched separators were around 11.5°, which were significantly lower than that of SV718. Moreover, the porosity and electrolyte uptake of sandwiched separators were over 81% and 910%, respectively, while those values of SV718 were 43% and 121%, respectively. The higher porosity, electrolyte uptake, and wettability of the sandwiched separators resulted in the better their cycling performance and higher specific‐discharge capabilities than SV718.Keywords
Funding Information
- Sunchon National University Research Fund 2015
This publication has 40 references indexed in Scilit:
- High performance ceramic-coated separators prepared with lithium ion-containing SiO2 particles for lithium-ion batteriesJournal of Power Sources, 2013
- Co-polyimide-coated polyethylene separators for enhanced thermal stability of lithium ion batteriesElectrochimica Acta, 2012
- Nano SiO2 particle formation and deposition on polypropylene separators for lithium-ion batteriesJournal of Power Sources, 2012
- Development and characterization of a bilayer separator for lithium ion batteriesJournal of Power Sources, 2011
- An inorganic membrane as a separator for lithium-ion batteryJournal of Power Sources, 2011
- Enhanced Wetting Behavior at Electrospun Polyamide Nanofiber SurfacesLangmuir, 2011
- Composite nonwoven separator for lithium-ion battery: Development and characterizationJournal of Power Sources, 2010
- Electrospun hydrophilic fumed silica/polyacrylonitrile nanofiber-based composite electrolyte membranesElectrochimica Acta, 2009
- Silica-Composite Nonwoven Separators for Lithium-Ion Battery: Development and CharacterizationJournal of the Electrochemical Society, 2008
- AC-impedance measurements during thermal runaway process in several lithium/polymer batteriesJournal of Power Sources, 2003