Optimization of fiber prediction model coefficients in injection molding simulation based on micro computed tomography
Authors:
- 5 December 2018
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 59 (s2) , E152-E160
Abstract
Fiber‐reinforced thermoplastic for low weight application become increasingly important for many industrial branches. During the injection molding of short fiber‐reinforced thermoplastic parts the fibers become orientated. This orientation is determined on the one hand by the geometry of the part, and on the other hand by the injection molding parameters, and influence the mechanical behavior of the part. The determination of the fiber properties that is, the orientation distribution of the fibers, is therefore of considerable interest. Since a more accurate fiber orientation prediction of the injection molding simulation will lead to a more precise structural simulation the objective of the present work is to achieve a preferably accurate orientation distribution. To describe the orientation distribution of the fibers, the fiber orientation tensor defined by Advani and Tucker (Advani and Tucker, Journal of Rheology, 31, 751 (1987)) was used. To determine the entries of this tensor micro computed tomography scans (μCT‐scans) of an injection‐molded plate, as well as an injection‐molded specimen with different cross section and shape were performed. Injection molding simulation using Autodesk Moldflow Insight were carried out. The residual strain closure (RSC) model was the underlying model to depict the fiber orientation distribution, or rather the orientation tensors. The two model parameters, the fiber interaction coefficient Ci and the scalar factor κ, were adapted by an optimization procedure, in such a way that the orientation distributions of the simulations fit the results of the μCT‐analysis at its best. POLYM. ENG. SCI., 59:E152–E160, 2019. © 2018 Society of Plastics EngineersKeywords
Funding Information
- Österreichische Forschungsförderungsgesellschaft
This publication has 23 references indexed in Scilit:
- An anisotropic rotary diffusion model for fiber orientation in short- and long-fiber thermoplasticsJournal of Non-Newtonian Fluid Mechanics, 2009
- An objective model for slow orientation kinetics in concentrated fiber suspensions: Theory and rheological evidenceJournal of Rheology, 2008
- Orthotropic closure approximations for flow-induced fiber orientationJournal of Rheology, 1995
- Determination of 3D fiber orientation distribution in thermoplastic injection moldingComposites Science and Technology, 1995
- Fiber orientation in simple injection moldings. Part I: Theory and numerical methodsPolymer Composites, 1992
- Numerical prediction of fiber orientation in injection moldingPolymer Engineering & Science, 1992
- Prediction of fiber orientation in injection molded parts of short‐fiber‐reinforced thermoplasticsPolymer Engineering & Science, 1990
- Numerical prediction of three‐dimensional fiber orientation in Hele‐Shaw flowsPolymer Engineering & Science, 1990
- Process induces fiber orientation: Numerical simulation with experimental verificationPolymer Composites, 1985
- The motion of ellipsoidal particles immersed in a viscous fluidProceedings of the Royal Society of London. Series A, Containing Papers of a Mathematical and Physical Character, 1922