Numerical Simulation of Impeller–Volute Interaction in Centrifugal Compressors
Authors:
- 1 July 1999
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 121 (3) , 603-608
Abstract
A numerical procedure to predict the impeller–volute interaction in a single-stage centrifugal compressor is presented. The method couples a three-dimensional unsteady flow calculation in the impeller with a three-dimensional time-averaged flow calculation in the volute through an iterative updating of the boundary conditions on the interface of both calculation domains. The method has been used to calculate the flow in a compressor with an external volute at off-design operation. Computed circumferential variations of flow angles, total temperature, and pressure are shown and compared with measurements. The good agreement between the predictions and measurements confirms the validity of the approach.Keywords
This publication has 9 references indexed in Scilit:
- Experimental Investigation of the Circumferential Static Pressure Distortion in Centrifugal Compressor Stages1997
- The Flowfield Calculations of a Centrifugal Pump With Volute1997
- Three-Dimensional Unsteady Flow and Forces in Centrifugal Impellers With Circumferential Distortion of the Outlet Static PressureJournal of Turbomachinery, 1997
- Aerodynamically Induced Radial Forces in a Centrifugal Gas Compressor: Part 2 — Computational Investigation1996
- Finite element calculations and experimental verification of the unsteady potential flow in a centrifugal volute pumpInternational Journal for Numerical Methods in Fluids, 1994
- Numerical Analysis of the Three-Dimensional Swirling Flow in Centrifugal Compressor VolutesJournal of Turbomachinery, 1994
- Two-Dimensional Flow Analysis of a Laboratory Centrifugal PumpJournal of Turbomachinery, 1992
- Unsteady flow calculation in a radial flow centrifugal pump with spiral casingInternational Journal for Numerical Methods in Fluids, 1991
- Rotating Wakes in Vaneless DiffusersJournal of Basic Engineering, 1960