Wear and Corrosion Resistance of Plasma Electrolytic Oxidation Coatings on 6061 Al Alloy in Electrolytes with Aluminate and Phosphate
Open Access
Abstract
Phosphate and aluminate electrolytes were used to prepare plasma electrolytic oxidation (PEO) coatings on 6061 aluminum alloy. The surface and cross-section microstructure, element distribution, and phase composition of the PEO coatings were characterized by SEM, EDS, XPS, and XRD. The friction and wear properties were evaluated by pin-on-disk sliding tests under dry conditions. The corrosion resistance of PEO coatings was investigated by electrochemical corrosion and salt spray tests in acidic environments. It was found that the PEO coatings prepared from both phosphate and aluminate electrolytes were mainly composed of α-Al2O3 and γ-Al2O3. The results demonstrate that a bi-layer coating is formed in the phosphate electrolyte, and a single-layered dense alumina coating with a hardness of 1300 HV is realizable in the aluminate electrolyte. The aluminate PEO coating had a lower wear rate than the phosphate PEO coating. However, the phosphate PEO coating showed a better corrosion resistance in acidic environment, which is mainly attributed to the presence of an amorphous P element at the substrate/coating interface.Keywords
This publication has 35 references indexed in Scilit:
- Castability and mechanical properties of new 7xxx aluminum alloys for automotive chassis/body applicationsJournal of Alloys and Compounds, 2017
- Development of lightweight Mg Li Al alloys with high specific strengthJournal of Alloys and Compounds, 2016
- Tribological behavior and mechanism of self-lubricating wear-resistant composite coatings fabricated by one-step plasma electrolytic oxidationTribology International, 2016
- Hybrid nanostructured aluminum alloy with super-high strengthNPG Asia Materials, 2015
- Wear and corrosion performance of two different tempers (T6 and T73) of AA7075 aluminium alloy after nitrogen implantationApplied Surface Science, 2015
- Effects of the ratio of anodic and cathodic currents on the characteristics of micro-arc oxidation ceramic coatings on Al alloysApplied Surface Science, 2014
- Grain Refiner Effect on the Microstructure and Mechanical Properties of the A356 Automotive WheelsJournal of Materials Engineering and Performance, 2013
- Control of the spatial distribution of porous alumina micro-domes formed during anodic oxidationElectrochimica Acta, 2009
- Spatial characteristics of discharge phenomena in plasma electrolytic oxidation of aluminium alloySurface and Coatings Technology, 2004
- The effect of a T6 heat treatment on the fretting wear of a SiC particle-reinforced A356 aluminum alloy matrix compositeWear, 2000