Experimental Study on the Flexural Behavior of over Reinforced Concrete Beams Bolted with Compression Steel Plate: Part I
Open Access
- 23 January 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (3) , 822
Abstract
The purpose of this paper is to investigate the flexural behavior of over-reinforced concrete beam enhancement by bolted-compression steel plate (BCSP) with normal reinforced concrete beams under laboratory experimental condition. Three beams developed with steel plates were tested until they failed in compression compared with one beam without a steel plate. The thicknesses of the steel plates used were 6 mm, 10 mm, and 15 mm. The beams were simply supported and loaded monotonically with two-point loads. Load-deflection behaviors of the beams were observed, analyzed, and evaluated in terms of spall-off concrete loading, peak loading, displacement at mid-span, flexural stiffness (service and post-peak), and energy dissipation. The outcome of the experiment shows that the use of a steel plate can improve the failure modes of the beams and also increases the peak load and flexural stiffness. The steel development beams dissipated much higher energies with an increase in plate thicknesses than the conventional beam.Keywords
Funding Information
- the Faculty Research Grant of the University of Malaya (UM). (Project No: GPF015A-2018)
This publication has 28 references indexed in Scilit:
- An Experimental and Numerical Study on the Flexural Performance of Over-Reinforced Concrete Beam Strengthening with Bolted-Compression Steel Plates: Part IIApplied Sciences, 2019
- Effect of reinforcement ratio on the flexural performance of hybrid FRP reinforced concrete beamsComposites Part B: Engineering, 2017
- Increasing ductility in heavily reinforced LWAC structuresEngineering Structures, 2014
- Effects of bolt–plate arrangements on steel plate strengthened reinforced concrete beamsEngineering Structures, 2010
- Effects of plastic hinges on partial interaction behaviour of bolted side-plated beamsJournal of Constructional Steel Research, 2010
- Theoretical and numerical analysis of reinforced concrete beams with confinement reinforcementRevista IBRACON de Estruturas e Materiais, 2008
- Effects of tensile reinforcement ratio and compressive strength on the behaviour of over-reinforced helically confined HSC beamsConstruction and Building Materials, 2007
- Behaviour of high strength axially loaded concrete columns confined with helicesConstruction and Building Materials, 2005
- Helically reinforced HSC beams reinforced with high strength steelInternational Journal of Materials and Product Technology, 2005
- Behaviour of externally confined high-strength concrete columns under eccentric loadingComposite Structures, 2003