Skin‐core debonding in resin‐infused sandwich structures
- 12 April 2015
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 37 (10) , 2974-2981
Abstract
Techniques for enhancing the interfacial fracture properties of foam‐based sandwich structures are investigated. Prior to manufacture, holes were drilled into a PET foam core in order to facilitate resin flow during the subsequent resin‐infusion process. Glass fibers were then inserted into the perforations in an attempt to increase the interfacial fracture toughness of the sandwich structure. The results from these tests are compared to data generated from similar tests on a plain PET core, as well as on samples in which no fiber reinforcement was incorporated into the vertical holes. The inclusion of fibers in the through‐thickness holes served to increase the skin‐core interfacial fracture toughness of the sandwich structures. Here, it was noted the highest values of fracture toughness were more than three times the value measured on the plain foam system. POLYM. COMPOS., 37:2974–2981, 2016. © 2015 Society of Plastics EngineersKeywords
This publication has 13 references indexed in Scilit:
- Numerical analysis of splice-type crack arrester with a filler under mode-I type loadingComposite Structures, 2013
- Experimental evaluation of splice-type crack arrester with a filler under mode-I type loadingComposite Structures, 2013
- Effect of stitch density and stitch thread thickness on compression after impact strength and response of stitched compositesComposites Science and Technology, 2012
- Investigation of failure mechanisms in GFRP sandwich structures with face sheet wrinkle defects used for wind turbine bladesComposite Structures, 2012
- Mechanical properties of sandwich panels with perforated foam coresJournal of Sandwich Structures & Materials, 2010
- Process Development Issues of Glass—Carbon Hybrid-reinforced Polymer Composite Wind Turbine BladesJournal of Composite Materials, 2009
- Fatigue Performance of Sandwich Beams With Peel StoppersStrain, 2009
- On the mechanical effect of stitch addition in sandwich panelComposites Science and Technology, 2006
- Novel stitch-bonded sandwich composite structuresComposite Structures, 2003
- Development of a new peel-stopper for sandwich structuresComposites Science and Technology, 2001