Optimisation of low dissipation micro-hotplates - Thermo-mechanical design and characterisation
Authors:
- 1 September 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 116, 116-121
Abstract
This work describes the results of a systematic investigation of micro-hotplates on thin isolating membranes capable of operation up to 600 °C both in static and dynamic mode. For the selection of optimum device geometry and the layer structure alternatives FEM analysis was applied. The materials considered were Si 3 N 4 , SiO 2 , TiO 2 /Pt, Al 2 O 3 and their combination in various multilayer structures. To reduce the chip size DRIE was selected for the release of the membrane. Experimental characterization of the hotplates was carried out by various techniques; the average hotplate temperature was deduced from the resistance of the applied Pt heater and verified by micro-melting point measurements. Buckling of the membranes was tested by means of optical methods and the cumulative stress of the multilayer structure quantified by Makyoh-topography. Pulsed mode cyclic heating revealed the dynamic properties and also served for accelerated stability tests. For demonstration microheater devices with heat dissipation up to 23 °C/mW and t 90 <; 3ms were constructed to form the basis of combustive type gas sensors operated at elevated temperature.Keywords
This publication has 19 references indexed in Scilit:
- A novel micro-pellistor based on nanoporous alumina beam supportJournal of Electronics (China), 2012
- A High-Performance Three-Dimensional Microheater-Based Catalytic Gas SensorIEEE Electron Device Letters, 2012
- Microhotplate temperature sensor calibration and BISTJournal of Research of the National Institute of Standards and Technology, 2011
- Microcantilever hotplates: Design, fabrication, and characterizationSensors and Actuators A: Physical, 2007
- Alternative micro-hotplate design for low power sensor arraysMicroelectronic Engineering, 2006
- High-temperature low-power performing micromachined suspended micro-hotplate for gas sensing applicationsSensors and Actuators B: Chemical, 2006
- Thermal optimization of micro-hotplates that have a silicon islandJournal of Micromechanics and Microengineering, 2002
- Design and simulations of SOI CMOS micro-hotplate gas sensorsSensors and Actuators B: Chemical, 2001
- Thermal modelling and characterisation of micropower chemoresistive silicon sensorsSensors and Actuators B: Chemical, 1997
- Si-planar-pellistor: designs for temperature modulated operationSensors and Actuators B: Chemical, 1996