IR sheet heating in roll fed thermoforming: Part 1 - Solving direct and inverse heating problems
- 1 September 2002
- journal article
- Published by SAGE Publications in Plastics, Rubber and Composites: Macromolecular Engineering
- Vol. 31 (7) , 307-317
Abstract
Published by Maney Publishing for the Institute of Materials, Minerals and Mining.Computational methods for modelling the heating stage in thermoforming of roll fed plastic sheet (direct problem) and for setting the temperatures of the heater bank to produce a prescribed sheet temperature (inverse problem) are presented, discussed, and experimentally validated. The algorithm computes the relevant local shape factors, and takes into account the effects of sag and of the surrounding air. The importance of same boundary conditions, such as air temperature, is discussed and quantitatively estimatedKeywords
This publication has 6 references indexed in Scilit:
- Application of one‐dimensional mechanical formulations to model the sagging behavior of a polymer sheetPolymer Engineering & Science, 1999
- Technology of Thermoforming1996
- Modelling of the One-Sided Infra-Red Heating of PolyurethaneJournal of Plastic Film & Sheeting, 1993
- Infrared radiation in the processing of plastics: Precise adjustment–the key to productivityAdvances in Polymer Technology, 1987
- Methods for the calculation of heating processes in thermoplastic semifinished productsAdvances in Polymer Technology, 1983
- Temperature distribution in semitransparent plastic sheets exposed to symmetric, unsymmetric, and pulsed radiant heating and surface coolingJournal of Applied Polymer Science, 1973