Effect of propane-methanol blending ratio on the stretched and unstretched flame speeds at elevated initial temperatures
Open Access
- 1 January 2022
- journal article
- research article
- Published by Centre for Evaluation in Education and Science (CEON/CEES) in FME Transactions
- Vol. 50 (2) , 121-130
Abstract
The unstretched flame speed of the premixed propane-methanol/ air flames has been studied experimentally in a constant volume combustion chamber with central ignition. The experiments were done at atmospheric pressure and stoichiometric air/fuel ratio. Various blending ratios of methanol (0%, 20%, 40%, 60%, 80%, 100%) by volume, and different elevated initial temperatures (348 K, 373 K, and 398 K) were used in this study. In general, the results indicated that the unstretched flame speed increased with increasing both methanol blending ratio and initial temperature. For M60 the increment value of unstretched flame speed at Ti=398K was about 9% compared with that of pure propane and by elevating the initial temperature for the same blend ratio (M60) from 348 K to 398 K the increment value was about 8.8%. It is also noticed that Markstein length decreased with increasing both initial temperature and blending ratio, which is indicate that flame instability increased with increasing these parameters.Keywords
This publication has 39 references indexed in Scilit:
- A laminar flame speed correlation of hydrogen–methanol blends valid at engine-like conditionsInternational Journal of Hydrogen Energy, 2013
- Laminar Flame Speed Measurements and Modeling of Pure Alkanes and Alkane Blends at Elevated PressuresJournal of Engineering for Gas Turbines and Power, 2011
- Measurements of laminar burning velocities and Markstein lengths for methanol–air–nitrogen mixtures at elevated pressures and temperaturesCombustion and Flame, 2008
- Investigation of nitrogen dilution effects on the laminar burning velocity and flame stability of syngas fuel at atmospheric conditionCombustion and Flame, 2008
- Outward propagation, burning velocities, and chemical effects of methane flames up to 60 ATMProceedings of the Combustion Institute, 2002
- The Measurement of Laminar Burning Velocities and Markstein Numbers for Iso-octane–Air and Iso-octane–n-Heptane–Air Mixtures at Elevated Temperatures and Pressures in an Explosion BombCombustion and Flame, 1998
- Response to comment by S.C. Taylor and D.B. Smith on “laminar burning velocities and Markstein numbers of hydrocarbon/air flames”Combustion and Flame, 1995
- Burning velocities of mixtures of air with methanol, isooctane, and indolene at high pressure and temperatureCombustion and Flame, 1982
- The pressure and temperature dependence of burning velocity in a spherical combustion bombSymposium (International) on Combustion, 1981
- Determination of burning velocities: A critical reviewCombustion and Flame, 1972