On the Stability of Operation of Antimony Sulfide Selenide Thin Film Solar Cells Under Solar Radiation
Authors:
- 7 October 2018
- journal article
- research article
- Published by Wiley in Physica Status Solidi (a)
- Vol. 215 (24)
Abstract
Operational stability of FTO/CdS/Sb2S1.08Se1.92/C‐Ag thin film solar cells under solar radiation is presented. These solar cells are produced on fluorine‐doped SnO2 (FTO) by thermal evaporation of Sb2S3 and Sb2Se3 powders. Thin film of Sb2S1.08Se1.92 (300 nm) shows a bandgap of 1.45 eV. Its electrical conductivity is 10−7 Ω−1 cm−1 (dark) and 10−5 Ω−1 cm−1 under illumination. Thin film of CdS (120 nm) for the solar cell is obtained on FTO by chemical deposition. Antimony chalcogenide film is deposited on FTO/CdS substrates maintained at 425 °C via thermal evaporation from a mixture of Sb2S3 and Sb2Se3 powders. Subsequently, graphite paint and silver paint electrodes of area 0.49–0.64 cm2 are applied on it. Efficiency of conversion (η) is 5.9 % for the best solar cell and 5.6% on an average for eight cells. Open circuit voltage (Voc) of the cell is 0.453 V; short circuit current density (Jsc), 24.7 mA cm−2; and fill factor, 0.53. For solar cells placed under the sun over 5 days in the exterior with exposure of 24 kWh m−2, η dropped to 5%. Under 30 suns, Voc of 0.54 V and Jsc of 130 mA cm−2 are recorded. The cells remained functional.Keywords
Funding Information
- CONACyT (122123)
- DGAPA-UNAM (PAPIIT100917)
- SENER-CONACYT (CeMIESol35)
This publication has 21 references indexed in Scilit:
- Antimony selenide thin-film solar cellsSemiconductor Science and Technology, 2016
- Simple solar cells of 3.5% efficiency with antimony sulfide-selenide thin filmsPhysica Status Solidi (RRL) – Rapid Research Letters, 2016
- Stability issues of the next generation solar cellsPhysica Status Solidi (RRL) – Rapid Research Letters, 2016
- Carbon-doped Sb2S3 thin films: Structural, optical and electrical propertiesSolar Energy Materials and Solar Cells, 2009
- Photoconductive Antimony Sulfide-Selenide Thin Films Produced by Heating a Chemically Deposited Se–Sb[sub 2]S[sub 3] LayerJournal of the Electrochemical Society, 2006
- High-efficiency polycrystalline CdTe thin-film solar cellsSolar Energy, 2004
- Chemically Deposited Sb2 S 3 and Sb2 S 3 ‐ CuS Thin FilmsJournal of the Electrochemical Society, 1998
- Conversion of chemically deposited photosensitive CdS thin films to n-type by air annealing and ion exchange reactionJournal of Applied Physics, 1994
- Vegard’s lawPhysical Review A, 1991
- Calculation of impact ionization enhanced photovoltaic efficiencySolar Cells, 1988