Effects of particle reinforcement on creep behaviour of AlSi1MgCu
- 1 July 2005
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 96 (7) , 807-813
Abstract
The creep resistance of an unreinforced and a particle-reinforced AlSi1MgCu alloy (AA6061) produced by liquid metallurgy was studied by means of conventional tensile creep tests at 300 °C. Dislocation-creep mechanism is attributed to both materials in the range of 15 – 50 MPa. The particlereinforced metal (PRM) exhibits a higher creep rate than the matrix alloy because of the particles acting as dislocation sources and the increase of the apparent diffusion coefficient due to a higher defect density. The apparently smaller creep exponent for the matrix is explained by the overaging of Mg2Si precipitates during longterm tests. Void formation leads to strain localisation in the unreinforced alloy, which is dispersed by the particles reducing the damage rate in the PRM. Subsequently, the time to rupture of the PRM surpasses that of the unreinforced matrix at creep stresses smaller than 10 –3 G (20 MPa).Keywords
This publication has 25 references indexed in Scilit:
- Creep properties of an Al-2024 composite reinforced with SiC particulatesMaterials Science and Engineering: A, 2002
- High temperature creep behaviour of an Al-8.5Fe-1.3V-1.7Si alloy reinforced with silicon carbide particulatesMaterials Science and Engineering: A, 2000
- Steady-state creep of a particulate SiC/6061 Al compositeActa Materialia, 2000
- Modeling the generation, equilibrium, and emission of dislocations at elastically misfitted particlesActa Materialia, 1998
- An examination of the effect of processing procedure on the creep of metal matrix compositesMaterials Science and Engineering: A, 1998
- Creep behavior of a reinforced Al-7005 alloy: Implications for the creep processes in metal matrix compositesActa Materialia, 1998
- Innovative light metals: metal matrix composites and foamed aluminiumMaterials & Design (1980-2015), 1997
- Use of Internal Variable Models to Predict the High Temperature Behaviour of a 6xxx Industrial AlloyMaterials Science Forum, 1996
- Comment on “steady state creep behaviour of silicon carbide reinforced aluminium composites”Scripta Metallurgica et Materialia, 1994
- Effects of reinforcement content and shape on cavitation and failure in metal-matrix compositesComposites, 1993