Compensation of process‐induced deformations of double‐curved carbon–epoxy composite elements
Author:
- 25 March 2019
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 40 (9) , 3666-3677
Abstract
The process‐induced deformations constitute a severe obstacle to composite part designing and manufacturing. Therefore, in the present work, a method of geometric compensation of those deformations is presented. The compensation process starts with the development of a calculation method which allows to calculate the deformations with the use of Finite Element Method. Linear elastic material model is used in the calculations. Then, the calculated deformations are used to design the compensated geometry of the tool which allows to decrease the deformations of the cured part. The compensation method was verified by compensating and manufacturing a double‐curved fragment of a composite wing leading edge. It appeared that the compensation method allowed to decrease the initial deformation of the structure fragment by approximately 77%. POLYM. COMPOS., 40:3666–3677, 2019. © 2019 Society of Plastics EngineersKeywords
This publication has 38 references indexed in Scilit:
- Modelling manufacturing deformations in corner sections made of composite materialsJournal of Composite Materials, 2013
- Cure kinetics modeling and cure shrinkage behavior of a thermosetting compositePolymer Engineering & Science, 2009
- Compensating Thermoset Composite Panel Deformation using Corrective MoldingJournal of Composite Materials, 2007
- Development of curvature during the cure of AS4/8552 [0/90] unsymmetric composite platesComposites Science and Technology, 2003
- Separation of gelation from vitrification in curing of a fiber‐reinforced epoxy compositePolymer Composites, 2002
- Spring-in and warpage of angled composite laminatesComposites Science and Technology, 2002
- Isolating Components of Processing Induced Warpage in Laminated CompositesJournal of Composite Materials, 2002
- A New Method to Reduce Cure-Induced Stresses in Thermoset Polymer Composites, Part III: Correlating Stress History to Viscosity, Degree of Cure, and Cure ShrinkageJournal of Composite Materials, 2000
- Separating Sources of Manufacturing Distortion in Laminated CompositesJournal of Reinforced Plastics and Composites, 2000
- Process-Induced Stress and Deformation in Thick-Section Thermoset Composite LaminatesJournal of Composite Materials, 1992