Cold forging method for polymer microfabrication
Authors:
- 19 October 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (10) , 1998-2004
Abstract
A polymer micro cold forging process was investigated. This method, derived from polymer solid‐phase forming, resembles more the metal‐forging method than the standard thermoplastic molding protocol. A micro‐forging die set was designed and fabricated and a series of cold forging experiments were carried out with varied process conditions, including forging speed, forging pressure, and dwell time. High‐aspect‐ratio microchannels were fabricated on polytetrafluoroethylene (PTFE) substrates. The dimension of replicated channels was found to be consistent from shot to shot. Owing to instantaneous elastic recovery, the channel has a width about 30% smaller than that on the die. The final channel size is contingent upon the forging process conditions, as well as upon the post‐recovery process. Upsetting experiments of PTFE cylindrical samples were carried out to study the fundamental issues on dimensional recovery so as to predict and consequently control the dimensional changes in polymer cold forging. Polym. Eng. Sci. 44:1998–2004, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 11 references indexed in Scilit:
- Development of rapid heating and cooling systems for injection molding applicationsPolymer Engineering & Science, 2002
- Development of Micro Punching SystemCIRP Annals, 2001
- Room-Temperature Imprinting Method for Plastic Microchannel FabricationAnalytical Chemistry, 2000
- Room-temperature imprint lithography by solvent vapor treatmentApplied Physics Letters, 2000
- Structurally Programmable Microfluidic Systems2000
- Advanced micromoulding of optical components1999
- Hydrophobic microfluidicsProceedings of SPIE, 1999
- Finite element analysis of metal forming processes with arbitrarily shaped diesInternational Journal of Mechanical Sciences, 1982
- A coupled analysis of viscoplastic deformation and heat transfer—IInternational Journal of Mechanical Sciences, 1980
- Review of forging, stamping, and other solid‐phase forming processesPolymer Engineering & Science, 1979