Mechanical properties of blends of nylon 6 with a chemically modified polyolefin
Authors:
- 1 January 1985
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 30 (1) , 165-177
Abstract
Both tensile and impact properties were measured of a heterogeneous polymer blend system, consisting of nylon 6 and a chemically modified polyolefin, DuPont CXA3095, which is an ethylene‐based multifunctional polymer. It was found, from the tensile testing, that the blends exhibited no signs of necking, and the addition of a soft resin (CXA3095) reduced the modulus and the tensile strength of nylon 6, whereas the percent elongation at break went through a minimum. When 20 wt % of CXA3095 was added to nylon 6, the impact strength was increased approximately three times. When the factors describing the interfacial adhesion were incorporated, the existing models for predicting the tensile modulus of blends were found to describe the experimental data rather well. In order to help explain the mechanical behavior observed, photomicrographs were taken of the fracture surfaces, using a scanning electron microscope.Keywords
This publication has 25 references indexed in Scilit:
- Rheological investigation of interfacial instability in two-layer flat-film coextrusionJournal of Polymer Engineering, 1984
- On the modulus of particulate‐filled composites: Application of van der Poel's equationJournal of Polymer Science: Polymer Physics Edition, 1976
- The effect of mixing on the modes of dispersion and rheological properties of two‐phase polymer blends in extrusionJournal of Applied Polymer Science, 1975
- Heterogeneous polymer–polymer composites. I. Theory of viscoelastic properties and equivalent mechanical modelsJournal of Applied Polymer Science, 1973
- Study of dynamic mechanical properties of poly(vinyl chloride)–ethylene vinyl acetate copolymer and poly(vinyl chloride)–chlorinated ethylene vinyl acetate copolymer mixturesJournal of Applied Polymer Science, 1972
- Dynamic Properties of a Model Reinforced Elastomer. Styrene-Butadiene Reinforced with PolystyreneMacromolecules, 1970
- Viscoelastic Behavior of Heterogeneous MediaJournal of Applied Mechanics, 1965
- Generalized model representation relating the degree of mixing to the rheological behavior of a mechanical mixture of two polymer componentsJournal of Applied Polymer Science, 1964
- The Elastic Moduli of Heterogeneous MaterialsJournal of Applied Mechanics, 1962
- Studies on heterogeneous polymeric systemsJournal of Polymer Science, 1956