Three-Dimensional Local Measurements of Bone Strain and Displacement: Comparison of Three Digital Volume Correlation Approaches
- 1 July 2015
- journal article
- research article
- Published by ASME International in Journal of Biomechanical Engineering
- Vol. 137 (7) , 071006
Abstract
Different digital volume correlation (DVC) approaches are currently available or under development for bone tissue micromechanics. The aim of this study was to compare accuracy and precision errors of three DVC approaches for a particular three-dimensional (3D) zero-strain condition. Trabecular and cortical bone specimens were repeatedly scanned with a micro-computed tomography (CT). The errors affecting computed displacements and strains were extracted for a known virtual translation, as well as for repeated scans. Three DVC strategies were tested: two local approaches, based on fast-Fourier-transform (DaVis-FFT) or direct-correlation (DaVis-DC), and a global approach based on elastic registration and a finite element (FE) solver (ShIRT-FE). Different computation subvolume sizes were tested. Much larger errors were found for the repeated scans than for the virtual translation test. For each algorithm, errors decreased asymptotically for larger subvolume sizes in the range explored. Considering this particular set of images, ShIRT-FE showed an overall better accuracy and precision (a few hundreds microstrain for a subvolume of 50 voxels). When the largest subvolume (50–52 voxels) was applied to cortical bone, the accuracy error obtained for repeated scans with ShIRT-FE was approximately half of that for the best local approach (DaVis-DC). The difference was lower (250 microstrain) in the case of trabecular bone. In terms of precision, the errors shown by DaVis-DC were closer to the ones computed by ShIRT-FE (differences of 131 microstrain and 157 microstrain for cortical and trabecular bone, respectively). The multipass computation available for DaVis software improved the accuracy and precision only for the DaVis-FFT in the virtual translation, particularly for trabecular bone. The better accuracy and precision of ShIRT-FE, followed by DaVis-DC, were obtained with a higher computational cost when compared to DaVis-FFT. The results underline the importance of performing a quantitative comparison of DVC methods on the same set of samples by using also repeated scans, other than virtual translation tests only. ShIRT-FE provides the most accurate and precise results for this set of images. However, both DaVis approaches show reasonable results for large nodal spacing, particularly for trabecular bone. Finally, this study highlights the importance of using sufficiently large subvolumes, in order to achieve better accuracy and precision.Keywords
This publication has 23 references indexed in Scilit:
- Microdamage assessment of bone-cement interfaces under monotonic and cyclic compressionJournal of Biomechanics, 2014
- About the inevitable compromise between spatial resolution and accuracy of strain measurement for bone tissue: A 3D zero-strain studyJournal of Biomechanics, 2014
- An efficient and accurate 3D displacements tracking strategy for digital volume correlationOptics and Lasers in Engineering, 2014
- Application of the digital volume correlation technique for the measurement of displacement and strain fields in bone: A literature reviewJournal of Biomechanics, 2014
- The application of digital volume correlation (DVC) to study the microstructural behaviour of trabecular bone during compressionJournal of the Mechanical Behavior of Biomedical Materials, 2014
- Computation of full-field displacements in a scaffold implant using digital volume correlation and finite element analysisMedical Engineering & Physics, 2013
- Measuring three‐dimensional strain distribution in tendonJournal of Microscopy, 2013
- Efficient computational fluid dynamics mesh generation by image registrationMedical Image Analysis, 2007
- Accuracy and precision of digital volume correlation in quantifying displacements and strains in trabecular boneJournal of Biomechanics, 2007
- Digital volume correlation: Three-dimensional strain mapping using X-ray tomographyExperimental Mechanics, 1999