TRANSIENT HEAT CONDUCTION DURING QUENCHING OF DOWNWARD FACING COPPER AND STAINLESS STEEL CONVEX SURFACES
Authors:
- 1 May 1996
- journal article
- research article
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 29 (6) , 543-573
Abstract
Quenching experiments were performed to determine the effect of watt material properties on pool boiling heat transfer for downward facing convex surfaces( radius of curvature 218.5 mm) in saturated water. Experiments employed 303e-type stainless steel and copper test sections having identical dimensions ( 75 mm in diameter and 20 mm thick). Pool boiling curves were constructed on the basis of two-dimensional numerical solution of transient heat conduction in spherical coordinates( r, 9) in test sections during quenching. The measured temperature histories at nine interior locations near the boiling surface ( ∼0.5 mm) provided a time-dependent boundary condition for the numerical solution. To ensure stability and reduce both computer storage and execution time, the numerical solution used the alternating direction implicit ( ADD method with control volume representations. A sensitivity analysis was conducted to assess the effect of grid size on computation time as well as the accuracy of calculated temperatures and pool boiling heat flux values. Best results were obtained using a 20 × 20 network of control volumes and a noniterative approach, whereas the computation time on a Pentium 90-MHz PC for the entire pool boiling curve was about 7% of real time. Calculated temperatures near the top surface ( ∼5 mm) agreed with measured values to within 0.5 and 2.5 K for copper and stainless steel, respectively. The error in the overall energy balance in the test section, performed after each time interval, was less than 0.001%. The thermal diffusivity of test section material strongly affected both radial conduction within the section and lateral conduction near the boiling surface and, hence, the local pool boiling curves as well as the maximum and minimum pool boiling heat flux values.Keywords
This publication has 9 references indexed in Scilit:
- Transient pool boiling from downward-facing curved surfacesInternational Journal of Heat and Mass Transfer, 1995
- POOL BOILING FROM DOWNWARD-FACING CURVED SURFACE IN SATURATED WATER1994
- Cooling of Core Debris Within the Reactor Vessel Lower HeadNuclear Technology, 1993
- Transient boiling from inclined and downward-facing surfaces in a saturated poolInternational Journal of Refrigeration, 1993
- An experimental study of saturated pool boiling from downward facing and inclined surfacesInternational Journal of Heat and Mass Transfer, 1992
- Angular Dependence of Boiling Heat Transfer Mechanisms in Liquid NitrogenAdvances in Cryogenic Engineering, 1988
- Suggested standard method for obtaining boiling curves by quenchingIndustrial & Engineering Chemistry Fundamentals, 1986
- Evaluation of the unsteady-state quenching method for determining boiling curvesInternational Journal of Heat and Mass Transfer, 1978
- Smoothing and Differentiation of Data by Simplified Least Squares Procedures.Analytical Chemistry, 1964