Experimental results for high-speed jitter measurement technique
Authors:
- H. HaggagHHH. Haggag
- J. HuardJHJ. Huard
- J. BraatzJBJ. Braatz
- 21 March 2005
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 85-94
Abstract
A BIST method to measure jitter without external references is presented. Measured data from 0.25- m BiCMOS chips show jitter resolution about 30 to 50 ps over 8 cycles of a 1 GHz input signal. The measurement technique uses the clock signal under test to control the charging of the input capacitance of an ADC. One advantage of this design is that it does not require an external jitter-free reference clock or a voltage reference. Design improvements from architectures to circuits are discussed and the method has potentials in other timing measurement applications.Keywords
This publication has 9 references indexed in Scilit:
- Cmos built-in test architecture for high-speed jitter measurement2004
- BIST for phase-locked loops in digital applications2003
- A four-channel self-calibrating high-resolution time to digital converter2002
- Measuring jitter of high speed data channels using undersampling techniques2002
- A synthesizable, fast and high-resolution timing measurement device using a component-invariant vernier delay line2002
- Strategies for on-chip sub-nanosecond signal capture and timing measurements2002
- A high-resolution jitter measurement technique using ADC sampling2002
- Interpolating time counter with 100 ps resolution on a single FPGA deviceIEEE Transactions on Instrumentation and Measurement, 2000
- A high resolution TDC in TKO box systemIEEE Transactions on Nuclear Science, 1988