Thermal Model for Sintered Cylindrical Evaporators of Loop Heat Pipes
- 1 January 2017
- journal article
- research article
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Thermophysics and Heat Transfer
- Vol. 31 (1) , 165-177
Abstract
A thermal analytical model for predicting the temperature distribution of a cylindrical geometry evaporator of a loop heat pipe is presented. The wick structure proposed is made of a thin layer of sintered metal powder and is considered filled with working fluid. The resulting porous medium has a thin uniform layer thickness, and it is modeled as flat plate operating in steady-state condition, in a two-dimensional Cartesian coordinate. A Laplace-type equation is solved. The methods of separation of variables and superposition are used to solve the mathematical problem. A scale analysis is used to obtain an expression relating the wick geometry and thermophysical properties. With these models, the loop heat pipe evaporation limit, given by the porous media-casing interface temperature, which must be lower than the working fluid saturation temperature, can be determined. A statistical experiment analysis technique was employed to study the influence of several parameters in the thermal model. Mathematical model results were compared with numerical simulation data for a loop heat pipe evaporator. Using the mathematical tool developed, a copper cylindrical evaporator of a loop heat pipe was designed, constructed, and tested, using an experimental setup especially constructed for this purpose. The good comparison between analytical results and data validates the model proposed.Keywords
This publication has 12 references indexed in Scilit:
- Complete analytical model of a loop heat pipe with a flat evaporatorInternational Journal of Thermal Sciences, 2015
- 3D-model for heat and mass transfer simulation in flat evaporator of copper-water loop heat pipeApplied Thermal Engineering, 2012
- Investigation of a compact copper–water loop heap pipe with a flat evaporatorApplied Thermal Engineering, 2011
- 3D heat transfer analysis in a loop heat pipe evaporator with a fully saturated wickInternational Journal of Heat and Mass Transfer, 2011
- Theoretical modelling of miniature loop heat pipeHeat and Mass Transfer, 2009
- Analytical Model for Characterization of Loop Heat PipesJournal of Thermophysics and Heat Transfer, 2008
- Operating Characteristics of Loop Heat PipesSAE International Journal of Advances and Current Practices in Mobility, 1999
- Mathematical modeling of loop heat pipes1999
- Investigation of heat and mass transfer in the evaporation zone of a heat pipe operating by the ‘inverted meniscus’ principleInternational Journal of Heat and Mass Transfer, 1994
- Analytical solutions of flow and heat transfer in a porous structure with partial heating and evaporation on the upper surfaceInternational Journal of Heat and Mass Transfer, 1994