Reactive DC Magnetron Sputter Deposited Titanium-Copper-Nitrogen Nano-Composite Thin Films with an Argon/Nitrogen Gas Mixture
Authors:
- A RahmatiARA Rahmati
- K AhmadiKAK Ahmadi
- 1 December 2010
- journal article
- Published by IOP Publishing in Plasma Science and Technology
- Vol. 12 (6) , 681-687
Abstract
A sintered Ti_(13)Cu_(87) target was sputtered by reactive direct current (DC) magnetron sputtering with a gas mixture of argon/nitrogen for different sputtering powers.Titanium-copper-nitrogen thin films were deposited on Si (111),glass slide and potassium bromide (KBr) substrates. Phase analysis and structural properties of titanium-copper-nitrogen thin films were studied by X-ray diffraction (XRD).The chemical bonding was characterized by Fourier transform infrared (FTIR) spectroscopy.The results from XRD show that the observed phases are nano-crystallite cubic anti rhenium oxide (anti ReO_3) structures of titanium doped Cu_3N (Ti:Cu_3N) and nanocrystallite face centered cubic (fcc) structures of copper.Scanning electron microscopy and energy dispersive X-ray spectroscopy (SEM/EDX) were used to determine the film morphology and atomic titanium/copper ratio,respectively.The films possess continuous and agglomerated structure with an atomic titanium/copper ratio (~0.07) below that of the original target (~0.15).The transmittance spectra of the composite films were measured in the range of 360 nm to 1100 nm.Film thickness,refractive index and extinction coefficient were extracted from the measured transmittance using a reverse engineering method.In the visible range,the higher absorption coefficient of the films prepared at lower sputtering power indicates more nitrification in comparison to those prepared at higher sputtering power.This is consistent with the formation of larger Ti:Cu_3N crystallites at lower sputtering power.The deposition rate vs.sputtering power shows an abrupt transition from metallic mode to poisoned mode.A complicated behavior of the films' resistivity upon sputtering power is shown.Keywords
This publication has 38 references indexed in Scilit:
- Effect of N2-Gas Partial Pressure on the Structure and Properties of Copper Nitride Films by DC Reactive Magnetron SputteringPlasma Science and Technology, 2007
- Effects of Ti on N distribution and diffusion in FeTiN thin filmsIEEE Transactions on Magnetics, 2005
- Process Simulation of Reactive DC Magnetron Sputtering for Thin Film Deposition of Niobium-Titanium NitrideIEEE Transactions on Applied Superconductivity, 2005
- Texture formation in sputter-deposited (Nb0.7,Ti0.3)N thin filmsJournal of Applied Physics, 2002
- Reactively sputtered Ti–B–N nanocomposite films: correlation between structure and optical propertiesThin Solid Films, 2002
- Co,Ni-base alloy thin films deposited by reactive radio frequency magnetron sputteringJournal of Vacuum Science & Technology A, 2001
- Structure and properties of hard and superhard Zr–Cu–N nanocomposite coatingsMaterials Science and Engineering: A, 2000
- Hard nanocomposite Zr–Y–N coatings, correlation between hardness and structureSurface and Coatings Technology, 2000
- Magnetron sputtering of alloy and alloy-based filmsThin Solid Films, 1999
- Cu3N Thin Film for a New Light Recording MediaJapanese Journal of Applied Physics, 1990