0.3 V ultra-low power sensor interface for EMG
Authors:
- 1 September 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 219-222
Abstract
A low-voltage, ultra-low power sensor interface for electromyogram (EMG) signal acquisition is presented. The sensor interface consists of an amplifier and a SAR ADC that work from a 0.3V supply. The low-voltage amplifier topology provides a noise level of 26μVrms, 40dB gain and a state-of the art power efficiency factor (PEF) of 2.2 from a 20-425Hz bandwidth. Low-voltage supply improves the power efficiency of the amplifier compared with previous ultra-low power work. Together with the ADC, the prototype implemented in 65nm CMOS process consumes 3.8nW and has an area of 0.22mm 2 , which makes the sensor interface suitable for wearable IoT nodes as well as implantable devices.Keywords
This publication has 6 references indexed in Scilit:
- A sub-μW 36nV/√Hz chopper amplifier for sensors using a noise-efficient inverter-based 0.2V-supply input stage2016
- A 0.20 $\text {mm}^2$ 3 nW Signal Acquisition IC for Miniature Sensor Nodes in 65 nm CMOSIEEE Journal of Solid-State Circuits, 2015
- Characterization of Human Body-Based Thermal and Vibration Energy Harvesting for Wearable DevicesIEEE Journal on Emerging and Selected Topics in Circuits and Systems, 2014
- 24.3 An implantable 64nW ECG-monitoring mixed-signal SoC for arrhythmia diagnosis2014
- Filtering the surface EMG signal: Movement artifact and baseline noise contaminationJournal of Biomechanics, 2010
- Charge–discharge characteristics of all-solid-state thin-filmed lithium-ion batteries using amorphous Nb2O5 negative electrodesJournal of Power Sources, 2007