Infill Density Influence on Mechanical and Thermal Properties of Short Carbon Fiber-Reinforced Polyamide Composites Manufactured by FFF Process
Open Access
Abstract
In three-dimensional (3D) printing, one of the main parameters influencing the properties of 3D-printed materials is the infill density (ID). This paper presents the influence of ID on the microstructure, mechanical, and thermal properties of carbon fiber-reinforced composites, commercially available, manufactured by the Fused Filament Fabrication (FFF) process. The samples were manufactured using FFF by varying the infill density (25%, 50%, 75%, and 100%) and were subjected to tensile tests, three-point bending, and thermal analyses by Differential Scanning Calorimetry (DSC) and Thermogravimetric Analysis (TGA). It was shown that the samples with 100% ID had the highest values of both tensile, 90.8 MPa, and flexural strengths, 114 MPa, while those with 25% ID had the lowest values of 56.4 MPa and 62.2 MPa, respectively. For samples with infill densities of 25% and 50%, the differences between the maximum tensile and flexural strengths were small; therefore, if the operating conditions of the components allow, a 25% infill density could be used instead of 50%. After DSC analysis, it was found that the variation in the ID percentage determined the change in the glass transition temperature from 49.6 °C, for the samples with 25% ID, to 32.9 °C, for those with 100% ID. TGA results showed that the samples with IDs of 75% and 100% recorded lower temperatures of onset degradation (approximately 344.75 °C) than those with infill densities of 25% and 50% (348.5 °C, and 349.6 °C, respectively).Keywords
Funding Information
- Ministry of Research, Innovation and Digitization, CNCS/CCCDI—UEFISCDI (PN-III-P2-2.1-PED-2019-0739)
This publication has 35 references indexed in Scilit:
- Heat distribution in material during fused deposition modellingRapid Prototyping Journal, 2018
- Properties of oriented carbon fiber/polyamide 12 composite parts fabricated by fused deposition modelingMaterials & Design, 2018
- Additive Manufacturing of PLA and CF/PLA Binding Layer Specimens via Fused Deposition ModelingJournal of Materials Engineering and Performance, 2018
- 3D printed stretching-dominated micro-trussesMaterials & Design, 2017
- Additive manufacturing in unmanned aerial vehicles (UAVs): Challenges and potentialAerospace Science and Technology, 2017
- Investigating the influence of infill percentage on the mechanical properties of fused deposition modelled ABS partsIngeniería e Investigación, 2016
- Interface and performance of 3D printed continuous carbon fiber reinforced PLA compositesComposites Part A: Applied Science and Manufacturing, 2016
- Additive manufacturing of carbon fiber-reinforced plastic composites using fused deposition modeling: Effects of process parameters on tensile propertiesJournal of Composite Materials, 2016
- 3D-printable CFR polymer composites with dual-cure sequential IPNsPolymer, 2016
- Highly oriented carbon fiber–polymer composites via additive manufacturingComposites Science and Technology, 2014