Research on Optimal Sensor Placement for Aircraft Structural Health Management
Authors:
- 1 June 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 31, 160-166
Abstract
Prognostic and Health Management (PHM) systems can manage health conditions of airplane real-time. As crucial subsystem of PHM, Aircraft Structural Health Management (ASHM) mainly focus on structural health monitoring and assessment, microstructure fault monitoring and isolation, overload, corrosion monitoring, residual life assessment and so on. It is overwhelmingly difficult for large aircraft structure to optimize sensor placement in ASHM on account of diversity of failure modes, hiddenness of fault position, incalculability of corrosion failure. Especially, corrosion detection, this is an intractable problem because corrosion degree is gradually accumulated with time. However, the Optimal Sensor Placement (OSP) is a vital aspect and plays a crucial role in data acquisition and data identification for the ASHM. Thus, thousands of sensors are installed for aircraft structure. Besides, failure models such as accidental damages, fatigue damages and corrosion, are often synergistic and interactive. Therefore, the OSP must be enough underlined for ASHM. In this paper, the OSP of aircraft wing structure had been discussed. Firstly, the test matrix was gained through modal test and the finite element model of wing structure was built by ANSYS. Secondly, sensor measuring points were optimized by the Singular Value Decomposition (SVD), the QR decomposition and the Fuzzy Measurement Coverage. Adopting singular value difference method and system fixed order method based on singular entropy had coped with sensor placement. The final result of the OSP had been verified by the QR decomposition and the Fuzzy Measurement Coverage. Finally, the scheme of OSP had been analyzed for aircraft wing structure. For the demand of the safety and reliability, at least 92 measuring points should be monitored for wing structure. Through analysis, about 18 measuring points could meet the demand for a wing. The final scenario of the OSP is that the strain of 10 measuring points and longitudinal and horizontal strain of eight wing-body joints are monitored. Numerous measuring points have been simplified and the effective information and data we need can be acquired for the wing.Keywords
This publication has 8 references indexed in Scilit:
- Numerical study on the optimal sensor placement for historic swing bridge dynamic monitoringStructure and Infrastructure Engineering, 2012
- Optimal Sensor Placement for Health Monitoring of High‐Rise Structure Based on Genetic AlgorithmMathematical Problems in Engineering, 2011
- Experimental Demonstration of H∞ Control based Active Vibration Suppression in Composite Fin-tip of Aircraft using Optimally Placed Piezoelectric Patch ActuatorsJournal of Intelligent Material Systems and Structures, 2007
- On the Computation of All Global Minimizers Through Particle Swarm OptimizationIEEE Transactions on Evolutionary Computation, 2004
- Methodology for Optimum Sensor Locations for Parameter Identification in Dynamic SystemsJournal of Engineering Mechanics, 1994
- Sensor placement for on-orbit modal identification via a genetic algorithmAIAA Journal, 1993
- Sensor Placement for On-Orbit Modal Identification and Correlation of Large Space Structures1990
- Optimal placement of excitations and sensors for verification of large dynamical systems1987