Industrial perspectives on earth abundant, multinary thin film photovoltaics
Authors:
- 28 February 2017
- journal article
- review article
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 32 (3) , 033004
Abstract
The most efficient earth abundant, non-toxic thin film multelemental PV devices are fabricated from Cu, Zn, Sn, S and Se, with the chemical formula of Cu 2 ZnSn(S x Se 1− x ) 4 (CZTS,Se). This material has enjoyed relatively rapid increases in efficiency from its inception to its present-day power conversion efficiency of 12.6%. But further increases in efficiency have been hampered by the inability to substantially increase Voc, the open circuit voltage. In this review article we will discuss the fundamentals of this important kesterite material including methods of film growth, post growth processing and device fabrication. Detailed studies of the properties of CZTS,Se including chemical, structural and electronic as well as full device electrical characterization have been performed in an effort to coax out the critical issues that limit performance. These experimental studies, enhanced by density functional theory calculations have pointed to fundamental bulk point defects, such as Cu–Zn antisites, and clusters of defects, as the primary culprits in limiting Voc increases. Improvements in device performance through grain boundary passivation and interface modifications are described. Exfoliation of functioning solar cells to expose the back surface along with engineering of new back contacts designed to impose electrostatic fields that drive electron-hole separation and increase Voc are discussed. A parallel route to increasing device performance by alloying Ag with CZTS,Se in order to inhibit Cu–Zn antisite defect formation has shown significant improvement in material properties. Finally, applications of high S (and hence higher Voc) CZTS,Se based devices to energy harvesting for ‘Internet-of-Things’ devices is discussed.Keywords
Funding Information
- U.S. Department of Energy (DE-EE0006334)
This publication has 78 references indexed in Scilit:
- Optimized fabrication of sputter deposited Cu2ZnSnS4 (CZTS) thin filmsSolar Energy, 2013
- Structural, optical and electrical properties of spray-deposited CZTS thin films under a non-equilibrium growth conditionJournal of Physics D: Applied Physics, 2012
- Novel Solution Processing of High‐Efficiency Earth‐Abundant Cu2ZnSn(S,Se)4 Solar CellsAdvanced Materials, 2012
- Implications for CdTe and CIGS technologies production costs of indium and tellurium scarcityProgress in Photovoltaics: Research and Applications, 2012
- Co-evaporated Cu2ZnSnSe4 films and devicesSolar Energy Materials and Solar Cells, 2012
- Doctor-bladed Cu 2 ZnSnS 4 light absorption layer for low-cost solar cell applicationChinese Physics B, 2012
- Earth‐Abundant Element Photovoltaics Directly from Soluble Precursors with High Yield Using a Non‐Toxic SolventAdvanced Energy Materials, 2011
- Comparative study of Cu2ZnSnS4 film growthSolar Energy Materials and Solar Cells, 2011
- The effect of Na in polycrystalline and epitaxial single-crystal CuIn1−xGaxSe2Thin Solid Films, 2005
- Cu2ZnSnS4 thin film solar cellsThin Solid Films, 2005