Patient-specific three-dimensional printed pulmonary artery model: A preliminary study
Authors:
- 1 October 2017
- journal article
- research article
- Published by Medknow in Digital Medicine
- Vol. 3 (4) , 170-177
Abstract
Background and Objectives: Three-dimensional (3D) printing has potential value in medical applications with increasing reports in the diagnostic assessment of cardiovascular diseases. The use of 3D printing in replicating pulmonary artery anatomy and diagnosing pulmonary embolism is very limited. The purpose of this study was to develop a 3D printed pulmonary artery model and test different computed tomography (CT) scanning protocols for determination of an optimal protocol with acceptable image quality but low radiation dose. Materials and Methods: A patient-specific 3D printed pulmonary artery model was created based on contrast-enhanced CT images in a patient with suspected pulmonary embolism. Different CT pulmonary angiography protocols consisting of 80, 100, and 120 kVp, pitch 0.7, 0.9, and 1.2 with 1 mm slice thickness, and 0.6 mm reconstruction interval were tested on the phantom. Quantitative assessment of image quality in terms of signal-to-noise ratio (SNR) was measured in the images acquired with different protocols. Measurements in pulmonary artery diameters were conducted and compared between pre- and post-3D printed images and 3D printed model. Results: The 3D printed model was found to replicate normal pulmonary artery with high accuracy. The mean difference in diameter measurements was P = 0.96-0.99). Radiation dose was reduced by 55% and 75% when lowering kVp from 120 to 100 and 80 kVp, without affecting image quality. Conclusions: It is feasible to produce a 3D printed pulmonary artery model with high accuracy in replicating normal anatomy. Different CT scanning protocols are successfully tested on the model with 80 kVp and pitch 0.9 being the optimal one with resultant diagnostic images but at much lower radiation dose.Keywords
This publication has 31 references indexed in Scilit:
- Piloting the Use of Patient-Specific Cardiac Models as a Novel Tool to Facilitate Communication During Cinical ConsultationsPediatric Cardiology, 2017
- Medical three-dimensional printing opens up new opportunities in cardiology and cardiac surgeryEuropean Heart Journal, 2017
- Modelling of aortic aneurysm and aortic dissection through 3D printingJournal of Medical Radiation Sciences, 2017
- Three-dimensional printed models in congenital heart diseaseThe International Journal of Cardiovascular Imaging, 2016
- Using 3D Printing to Create Personalized Brain Models for Neurosurgical Training and Preoperative PlanningWorld Neurosurgery, 2016
- Advantages and disadvantages of 3-dimensional printing in surgery: A systematic reviewSurgery, 2016
- Use of 3D printed models in medical education: A randomized control trial comparing 3D prints versus cadaveric materials for learning external cardiac anatomyAnatomical Sciences Education, 2015
- Advances in the diagnosis and management of acute pulmonary embolismThrombosis Research, 2014
- Rethinking Testing for Pulmonary Embolism: Less Is MoreAnnals of Emergency Medicine, 2011
- Strategies for Reducing Radiation Dose in CTRadiologic Clinics of North America, 2009