Investigation of the causes for the cardan coupling universal cross joint (UCJ) sleeve failure
Preprint
- 27 March 2026
- preprint
- Published by Elsevier in SSRN Electronic Journal
Abstract
In steel rolling mill, significant volumetric and surface damage was generated on UCJ sleeves of the cardan coupling. The surface damage appeared as severe contact plastic deformations, and the volumetric damage occurred as one of the driven sleeves fracture. In order to explain these damages on the driven sleeve of the UCJ, appropriate theoretical, numerical and experimental researches were carried out. Analytical methods were used to consider the influence of the geometric characteristics of the sleeve on the load distribution along the contact line of the parts in contact: the rolling elements of the needle bearing and the sleeve. The influence of load distribution on the load capacity and strength of the sleeve in critical cross-section was also considered using analytical methods. Using the FEM, the influence of stress concentration on the stress state of the sleeve was analyzed. The fracture surface of the sleeve, plastic deformations and mechanical characteristics of the material were analyzed using experimental methods. These tests revealed a notch in the tension zone of the fractured surface of driven sleeve, which is the main cause of the fracture. Conducted research showed that firstly volumetric, and then surface damage was generated on the driven sleeve of the UCJ. The initial volumetric damage caused a change in the position of the parts in contact: the sleeve and the bearing’s rolling elements. This led to the generation of an extremely uneven line load distribution on the contact surfaces. High local contact stress then caused a significant amount of plastic deformation on the UCJ driven sleeves.Keywords
This publication has 8 references indexed in Scilit:
- Fatigue resistance performance of universal cardan joint for automotive applicationEngineering Failure Analysis, 2022
- A comprehensive analysis of failure of cross bearing of universal spindle in Hot Strip MillEngineering Failure Analysis, 2019
- Fatigue Fracture of a Locomotive Diesel Engine Cardan-ShaftJournal of Failure Analysis and Prevention, 2014
- Dynamics of universal joints, its failures and some propositions for practically improving its performance and life expectancyJournal of Mechanical Science and Technology, 2012
- Analysis of the drive shaft fracture of the bucket wheel excavatorEngineering Failure Analysis, 2012
- Investigation of causes of fan shaft failureEngineering Failure Analysis, 2010
- Two cases of failure in the power transmission system on vehicles: A universal joint yoke and a drive shaftEngineering Failure Analysis, 2007
- Automotive component failuresEngineering Failure Analysis, 1998