Experimental and theoretical investigations of some useful langasite cuts for high-temperature SAW applications
- 29 March 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 60 (4) , 814-823
Abstract
Passive high-temperature sensors are a most promising area of use for SAW devices. Langasite (La 3 Ga 5 SiO 14 ; LGS) has been identified as promising piezoelectric material to meet high-temperature SAW challenges. Because it is necessary to know the material behavior for an accurate device design, the frequency-temperature behavior of Rayleigh SAW (R-SAW) and shear-horizontal SAW (SH-SAW) LGS cuts is investigated on delay line and resonator test structures up to 700°C by RF characterization. In the range of the 434-MHz ISM band, the (0°, 22°, 90°) SH-SAW cut shows thermal behavior similar to the (0°, 138.5°, 26.7°) R-SAW cut. Associated with the (0°, 22°, 31°) cut, in which SAWs present mixed types of polarization, the (0°, 22°, 90°) SH-SAW orientation might allow differential measurements on a single substrate. In the temperature range of 400 to 500°C, delay line test devices using the SH-SAW cut show a considerable drop of signal. Theoretical analysis indicates that this newly described behavior might be a result of anisotropy effects in this cut, occurring in case of any slight misorientation of electrode alignment.Keywords
This publication has 21 references indexed in Scilit:
- Effect of anisotropy on characteristics and behavior of shear horizontal SAWs in resonators using langasiteIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2012
- Characterization of langasite for application in high temperature SAW sensors2012
- Behavior of platinum/tantalum as interdigital transducers for SAW devices in high-temperature environmentsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2011
- Influence of packaging atmospheres on the durability of high-temperature SAW sensors2009
- Characterisation setup of SAW devices at high temperatures and ultra high frequencies2009
- High temperature stability of langasite surface acoustic wave devices2008
- P1I-5 Micro-Machined, All Quartz Package, Passive Wireless SAW Pressure and Temperature Sensor2006
- Prediction of the thermal sensitivity of surface acoustic waves excited under a periodic grating of electrodesIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2005
- Multi-Band SAW Filter Design Using the Remez Exchange Algorithm1983
- Surface Acoustic Wave Multielectrode TransducersIEEE Transactions on Sonics and Ultrasonics, 1975