Comparative study of the influence of graphene nanoplatelets filler on the mechanical and tribological behavior of glass fabric‐reinforced epoxy composites
- 13 September 2020
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 41 (12) , 5403-5417
Abstract
The objective of this article is to examine the influence of different weight percentages (wt%) of graphene nanoplatelets (GNPs) on the behavior of mechanical and abrasive wear. Furthermore, the influence of operating parameters, such as, different degrees of applied loads and abrading distance (5‐20 N and 100‐250 m, respectively) at a rotational speed of 200 rpm (1.047 m/s) against SiC paper of 400 grit size was studied. From the present study, it was possible to establish that performance of the glass fabric‐reinforced epoxy composite materials can be improved with incorporation of GNPs. Moreover, incorporation of a large amount (1 wt%) of GNPs was found to noticeably enhance the tribo‐performance, ILSS, and hardness of the composite materials. However, the tensile strength was noted to increase negligibly with incorporation of 1 wt% of GNPs as compared to 0.5 wt% of GNPs. To get an insight into the wear mechanisms, the abraded surface of the tribological samples was examined by scanning electronic microscopy and energy dispersive X‐ray. Their morphology was correlated with wear volume and specific wear rate data trends. Worn surface features analysis indicated that incorporation of GNPs mainly improved the fiber‐matrix interface, which resists easy pullout of fibers from matrix/fillers and enables higher wear resistance.Keywords
This publication has 58 references indexed in Scilit:
- Reversible Loss of Bernal Stacking during the Deformation of Few-Layer Graphene in NanocompositesACS Nano, 2013
- Solid particle erosion behaviour of glass fibre reinforced boric acid filled epoxy resin compositesTribology International, 2011
- Abrasive wear behaviour of hard powders filled glass fabric–epoxy hybrid compositesMaterials & Design (1980-2015), 2011
- Investigations on mechanical and two-body abrasive wear behaviour of glass/carbon fabric reinforced vinyl ester compositesMaterials & Design (1980-2015), 2009
- Fundamental aspects and recent progress on wear/scratch damage in polymer nanocompositesMaterials Science and Engineering: R: Reports, 2009
- Mechanical Properties of Glass-Fiber Reinforced Epoxy Composites Filled with Al 2O3 ParticlesJournal of Reinforced Plastics and Composites, 2008
- Mechanical and three‐body abrasive wear behaviour of SiC filled glass‐epoxy compositesPolymer Composites, 2008
- Evaluation of glass fiber reinforced polyester composite for multi-pass abrasive wear applicationsWear, 2007
- Carbon fiber reinforced plastics in aircraft constructionMaterials Science and Engineering: A, 2005
- Friction and wear of advanced composite materialsFibre Science and Technology, 1983