Measurements of the effectiveness of dust control on cut-off saws used in the construction industry
Authors:
Open Access
- 1 October 1999
- journal article
- research article
- Published by Oxford University Press (OUP) in Annals of Occupational Hygiene
- Vol. 43 (7) , 443-456
Abstract
Materials used in the construction industry frequently contain large quantities of silica. When they are cut or shaped with power tools considerable respirable dust can be produced. Three dust control systems for use with cut-off saws have been evaluated on site: wet dust suppression using mains water, the same system using water from a portable water tank, and local exhaust ventilation. The efficiency of water suppression on cut-off saws has been precisely quantified in controlled laboratory conditions by means of measurements with and without dust control. When dust control was used on-site, the mean concentrations of airborne silica were reduced by a factor of between three and seven, the accuracy being limited by the relatively high limit of detection for silica. All controls systems generally reduced respirable dust levels by at least 90%. Although the effectiveness of dust suppression did not depend on blade type, a diamond blade was more effective than a resin-bonded blade with the pressurised water system; cutting a slab with this type of blade could be completed before the water tank required repressurisation. In laboratory tests, the application of water reduced the dust concentration to <4% of its value without control. The method for monitoring the dust concentration was sufficiently sensitive to measure a difference in concentration produced during cutting in different directions. It is important, however, that the pressure in supply reservoirs is properly maintained, that the water is correctly applied and that it is used at the correct rate. If this is done effective dust control can be achieved.Keywords
This publication has 3 references indexed in Scilit:
- MEASUREMENTS OF THE EFFECTIVENESS OF DUST EXTRACTION SYSTEMS OF HAND SANDERS USED ON WOOD*Annals of Occupational Hygiene, 1994
- FIELD COMPARISON OF PERSONAL SAMPLERS FOR INHALABLE DUSTAnnals of Occupational Hygiene, 1990
- The design of an aerosol test tunnel for occupational hygiene investigationsAtmospheric Environment (1967), 1986