Flow and heat transfer characteristics of 3D printed sheet and solid triply periodic minimal surfaces porous structures
Authors:
Open Access
- 10 August 2025
- journal article
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 29255
Abstract
Triply periodic minimal surfaces (TPMS) are recently widely employed in thermal engineering applications due to their smooth surfaces, high surface area to volume ratio and mathematically controlled geometry features. Although the sheet-type TPMS shows good heat transfer capacity between the fluid and the skeleton surface, the pressure drop of this structure is large resulting from its partially disconnected surface. In this paper, four TPMS structures, sheet Gyroid, solid Gyroid, solid Primitive and solid Diamond were designed and manufactured by 3D printing technology. The heat transfer performance of different TPMS structures and the fin structure was researched by means of computational fluid dynamics (CFD) simulations and experimental methods. The results showed that the heat dissipation capability of the fin structure was better than that of the TPMS structures under ultra-low speed airflow. Otherwise, the heat transfer performance of the solid TPMS is better than both of the sheet TPMS and the fins structures. Although the sheet TPMS has higher surface area compared to the solid TPMS, the flow speed was decreased along the internal channels leading to greater thermal resistance and lower thermal transferring efficiency. When the gas velocity was less than 4 m/s, the solid Gyroid expressed the best performance among the three solid TPMS structures caused by its higher surface area connected to the heat source. Under higher gas velocity, the solid Diamond was proved to have better performance led by higher flow speed within channels. The heat transfer coefficient of solid Diamond was 110% and 59% larger than that of the solid Primitive and the solid Gyroid, respectively. The Nusselt number of solid Diamond was 10% and 12% greater than that of the solid Primitive and the solid Gyroid, respectively. The research proves that the solid TPMS can be used to replace the fin structure in heat exchangers and provides a basis for design and optimization of TPMS-based heat exchangers in the future.Keywords
Funding Information
- the Graduate Research and Innovation Projects of Jiangsu Province (KYCX22_1621)
- National Natural Science Foundation of China (52005268, 32171358, 32171358)
- the Open Research Fund of Guangdong Key Laboratory of Minimally Invasive Surgical Instruments and Manufacturing Technology, Guangdong University of Technology (MISIMT-2021-5)
- the Natural Science Fund for Colleges and Universities in Jiangsu Province (20KJA460004)
This publication has 26 references indexed in Scilit:
- Heat transfer analysis of a PCM in shell-and-tube thermal energy storage unit with different V-shaped fin structuresApplied Thermal Engineering, 2022
- Fluid flow and heat transfer of porous TPMS architected heat sinks in free convection environmentCase Studies in Thermal Engineering, 2022
- Heat transfer and pressure drop characteristics of heat exchangers based on triply periodic minimal and periodic nodal surfacesApplied Thermal Engineering, 2022
- Weight and performance optimization of rectangular staggered fins heat exchangers for miniaturized hydraulic power units using genetic algorithmCase Studies in Thermal Engineering, 2021
- A review of topology optimization for additive manufacturing: Status and challengesChinese Journal of Aeronautics, 2021
- Additively manufactured heat exchangers: a review on opportunities and challengesThe International Journal of Advanced Manufacturing Technology, 2020
- Mechanical behavior of TPMS-based scaffolds: a comparison between minimal surfaces and their lattice structuresSN Applied Sciences, 2019
- Design Optimization of Heat Exchangers with Advanced Optimization Techniques: A ReviewArchives of Computational Methods in Engineering, 2019
- Mechanical properties of energy-absorbing structures with triply periodic minimal surface topologyActa Astronautica, 2018
- Minimal surface scaffold designs for tissue engineeringBiomaterials, 2011