Microstructural development of adiabatic shear bands in ultra-fine-grained low-carbon steels fabricated by equal channel angular pressing
Authors:
- Sunghak LeeSLSunghak Lee
- Nack J. KimNKNack J. Kim
- 1 December 2006
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 441 (1-2) , 308-320
Abstract
No abstract availableKeywords
This publication has 30 references indexed in Scilit:
- Dilatometric analysis on phase transformations of intercritical annealing of Fe−Mn−Si and Fe−Mn−Si−Cu low carbon TRIP steelsMetals and Materials International, 2004
- Dynamic recrystallization in high-strain, high-strain-rate plastic deformation of copperActa Metallurgica et Materialia, 1994
- Adiabatic shear band formation during dynamic torsional deformation of an HY-100 steelActa Metallurgica et Materialia, 1993
- Observation of an adiabatic shear band in AISI 4340 steel by high-voltage transmission electron microscopyMetallurgical Transactions A, 1990
- An experimental study of the formation process of adiabatic shear bands in a structural steelJournal of the Mechanics and Physics of Solids, 1988
- Measurement of the temperature profile during shear band formation in steels deforming at high strain ratesJournal of the Mechanics and Physics of Solids, 1987
- Observation of an adiabatic shear band in titanium by high-voltage transmission electron microscopyActa Metallurgica, 1986
- The structure of adiabatic shear bands in a titanium alloyActa Metallurgica, 1985
- Shear bands in deformed metalsScripta Metallurgica, 1984
- Adiabatic Plastic DeformationAnnual Review of Materials Science, 1979