Effect of Moisture State on Mechanical Behavior and Microstructure of Pulp Fiber-Cement Mortars
Authors:
- 1 August 2007
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 19 (8) , 691-699
Abstract
An investigation involving mechanical testing and microstructural characterization was undertaken to examine the influence of moisture state at the time of testing on the performance (i.e., strength, toughness, and failure mode) of pulp fiber-cement composites. Samples, prepared with fiber volume fractions of 0, 1.2, and 2.0%, were tested in oven dry, air dry, and wet states. Both compressive and flexural strength were found to be greatest in the oven dry state, presumably due to increased fiber and matrix strength as well as increased fiber/cement bonding which occurs with the controlled removal of water. Flexural toughness, however, was decreased for oven dry samples, and greater fiber fracture (as opposed to the more ductile failure mode of fiber pull-out) was observed in the oven dry samples. It is proposed that this results from differential shrinkage in the fibers’ S1 and S2 layers and increased fiber/cement bonding with drying.Keywords
This publication has 10 references indexed in Scilit:
- Durability of kraft pulp fiber–cement composites to wet/dry cyclingCement and Concrete Composites, 2005
- Durability of pulp fiber-cement composites to wet/dry cycling2002
- Aging mechanisms in cellulose fiber reinforced cement compositesCement and Concrete Composites, 1999
- Wood Fiber Reinforced Cement Composites under Wetting‐Drying and Freezing‐Thawing CyclesJournal of Materials in Civil Engineering, 1994
- Moisture Effects on Flexural Performance of Wood Fiber‐Cement CompositesJournal of Materials in Civil Engineering, 1992
- Fibre-matrix interface in air-cured wood-pulp fibre-cement compositesJournal of Materials Science Letters, 1987
- Reinforcement of Griffith flaws in cellulose reinforced cement compositesJournal of Materials Science Letters, 1985
- Bonding in wood fibre-cement compositesJournal of Materials Science, 1984
- Autoclaved beaten wood fibre-reinforced cement compositesComposites, 1984
- Effects of water and bleaching on the mechanical properties of cellulose fibre cementsJournal of Materials Science, 1983