Additive manufacturing of component based on polyethylene terephthalate glycol: multi-response optimization using grey relational analysis
- 8 April 2025
- journal article
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (2) , 025402
Abstract
This work details the experimental investigations of additive manufacturing (AM) of components based on Polyethylene Terephthalate Glycol (PETG) and subsequent multi-response optimization through grey relational analysis (GRA). The effect of layer thickness (LT), infill density (ID), and raster angle (RA) on the hardness and compressive strength of the PETG component was assessed. The GRA revealed that the optimal values of the input parameters for the best combination of hardness and compressive strength are LT—0.1 mm, ID—1, and RA—90°. The values of compressive strength and hardness at the optimal condition were 34.89 MPa and 84.97, respectively. The high F-value for ID (379.18) obtained from the variance analysis indicates that the ID has the most significant influence on the responses. The R-sq value for grey relational grade (GRG) being 97.51% signifies the fitness of the regression model. The delamination and crushing of layers were observed in the optical micrographs of the tested specimens.Keywords
This publication has 26 references indexed in Scilit:
- Influence of 3D Printing FDM Process Parameters on Compressive Strength of PLA/Carbon Fiber Composites: ANOVA and Backpropagation Neural Network ApproachJournal of Materials Engineering and Performance, 2025
- Multi-objective optimization of material extrusion additively manufactured parts from PETG feedstock material using grey wolf algorithmProgress in Additive Manufacturing, 2024
- Development of 3D printed novel multi-polymer component based on blended filaments of polylactic acid and polyethylene terephthalate glycolProgress in Additive Manufacturing, 2024
- Multi‐objective optimization of 3D printing process parameters using gray‐based Taguchi for composite PLA partsPolymer Composites, 2024
- Additive Manufacturing of Sensors: A Comprehensive ReviewInternational Journal of Precision Engineering and Manufacturing-Green Technology, 2024
- Optimization of 3D printed polylactic acid structures with different infill patterns using Taguchi-grey relational analysisAdvanced Industrial and Engineering Polymer Research, 2023
- Advances in orthodontic clear aligner materialsBioactive Materials, 2022
- Critical review of FDM 3D printing of PLA biocomposites filled with biomass resources, characterization, biodegradability, upcycling and opportunities for biorefineriesApplied Materials Today, 2021
- A 3D Printed Wearable Bioelectronic Patch for Multi‐Sensing and In Situ Sweat Electrolyte MonitoringAdvanced Materials Technologies, 2021
- Multi-objective optimization of hole dilation at inlet and outlet during machining of CFRP by μEDM using assisting-electrode and rotating toolThe International Journal of Advanced Manufacturing Technology, 2020