Effects of Casting Conditions for Reduced Pressure Test on Melt Quality of Al-Si Alloy
Open Access
Abstract
The present study investigated the effect of the casting conditions for the reduced pressure test (RPT) on the melt quality of Al-Si alloy. The casting conditions considered in RPT were the atmospheric exposure during melting, sampling method, and mold pre-heating temperature. Density Index (DI) was measured to quantify the melt quality of the Al-Si alloy casted with the different casting conditions for the RPT. The sample with blocking atmospheric exposure during melting was 5.6% lower in DI than the one without blocking. DI showed a 1.9% gap between scooping-out and pouring sampling methods. Increasing mold pre-heating temperature from 100 °C to 250 °C increased the DI of the alloy from 8.5% to 18.7%. On the other hand, when the mold pre-heating temperature was 350 °C, the DI of the alloy dropped sharply to 0.9%. The melt quality of the alloys was analyzed by measuring the pores and microstructure and simulating the solidification of the samples. It was presumed that the oxides and inclusions in the molten alloys caused the difference in DI according to the atmospheric exposure and the sampling method. The difference in DI according to the mold pre-heating temperature could be understood by calculating the solidification starting time and hydrogen diffusion coefficient during the solidification of the alloys in RPT.Keywords
Funding Information
- Ministry of Trade, Industry and Energy (10081329)
- Ministry of SMEs and Startups (S2640396)
This publication has 16 references indexed in Scilit:
- Effects of Mg Content on Hydrogen Content and Melt Quality of Al-Mg AlloysMetals, 2019
- Determination of Acceptable Quality Limit for Casting of A356 Aluminium Alloy: Supplier’s Quality Index (SQI)Metals, 2019
- Effect of Alloying Elements on the Thermal Conductivity and Casting Characteristics of Aluminum Alloys in High Pressure Die CastingKorean Journal of Metals and Materials, 2018
- Superior light metals by texture engineering: Optimized aluminum and magnesium alloys for automotive applicationsActa Materialia, 2013
- Bubbles engulfment and entrapment by cellular and dendritic interfaces during directional solidificationJournal of Crystal Growth, 2012
- Porosity, hydrogen and bifilm content in Al alloy castingsMaterials Science and Engineering: A, 2011
- On-line prediction of the melt hydrogen and casting porosity level in 319 aluminum alloy using thermal analysisMaterials Science and Engineering: A, 2006
- OXIDE INCLUSION DEFECTS IN Al-Si-Mg CAST ALLOYSCanadian Metallurgical Quarterly, 2005
- Recent development in aluminium alloys for the automotive industryMaterials Science and Engineering: A, 2000
- Diffusion-controlled growth of hydrogen pores in aluminium–silicon castings: in situ observation and modellingActa Materialia, 2000