Investigation on Mechanical Properties and Analysis of Dry Sliding Wear Behavior of Al LM13/AlN Metal Matrix Composite Based on Taguchi's Technique
Authors:
- 4 April 2017
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 139 (4) , 041602
Abstract
LM13/AlN (10 wt. %) metal matrix composites (MMC) and unreinforced aluminum alloy were produced under stir casting route. Microstructural characteristics were examined on the developed composite using optical microscope. The hardness and tensile test were carried out on both unreinforced aluminum alloy and composite using Vickers hardness tester and universal testing machine (UTM), respectively. Dry sliding wear behavior of the composite and unreinforced aluminum alloy was evaluated using pin-on-disk tribometer based on the design of experiments approach. Experimental parameters such as applied load (10, 20, and 30 N), velocity (1, 2, and 3 m/s), and sliding distance (500, 1000, and 1500 m) were varied for three levels. Signal-to-noise (S/N) ratio analysis, analysis of variance, and regression analysis were also performed. The characterization results showed that reinforcement particles were uniformly distributed in the composite. The hardness and tensile test revealed greater improvement of property in composite compared to that of unreinforced alloy. Wear plot showed that wear was increased with increase in load and decreased with increase in velocity and sliding distance. S/N ratio analysis and analysis of variance (ANOVA) indicated that load has greater significance over the wear rate followed by velocity and sliding distance. Regression analysis revealed greater adequacy with the constructed model in predicting the wear behavior of composite and unreinforced aluminum alloy. Scanning electron microscopy (SEM) analysis is evident that the transition of wear from mild to severe occurred on increase of the load in the composite.Keywords
This publication has 10 references indexed in Scilit:
- Mechanical and tribological properties of functionally graded aluminium/zirconia metal matrix composite synthesized by centrifugal castingInternational Journal of Materials Research, 2015
- Dry Sliding Wear Behaviour of Aluminium Al–Si12Cu/TiB2 Metal Matrix Composite Using Response Surface MethodologyTribology Letters, 2015
- Development of Aluminium Based Silicon Carbide Particulate Metal Matrix Composite for Spur GearProcedia Materials Science, 2014
- Study on mechanical and wear properties of Al 7075/Al2O3/graphite hybrid compositesComposites Part B: Engineering, 2014
- Wear performance of Al–SiC–B4C hybrid composites under dry sliding conditionsMaterials & Design (1980-2015), 2013
- Microdeformation behaviour of Al–SiC metal matrix compositesComposite Interfaces, 2008
- Tribological behavior of Al–Si–SiCp composites/automobile brake pad system under dry sliding conditionsTribology International, 2007
- Transition between mild and severe wear in aluminium alloysActa Materialia, 1997