Modeling Air Aspiration in Steel Continuous Casting Slide-Gate Nozzles
Open Access
Abstract
Air aspiration is an important cause of nozzle clogging and inclusions in final products of continuous casting of steel due to the presence of metal oxides (such as alumina) which occur through the reoxidation of molten steel. This problem is most likely to occur when the flow control system (slide-gate or stopper rod) causes the pressure inside the nozzle to drop below atmospheric pressure, drawing gas into the system through possible cracks or gaps in the refractory walls. In this work, a 1-D pressure-energy model of the complete metal delivery system from the tundish to the mold is developed to predict the pressure distribution and throughput under dynamic operating conditions and varying clogging conditions. The energy balance approach includes pressure losses in the slide-gate, wall friction, and nozzle geometry variations, including the effects of multiphase flow due to argon gas injection. The model also predicts air aspiration, oxide inclusion formation, and the time for clogging shutdown. The predicted pressure distribution is verified with a three-dimensional numerical simulation of multiphase turbulent flow, and is validated with plant measurements. Parametric studies with different submerged entry nozzle (SEN) designs revealed that a smaller SEN diameter may lessen negative pressure by redistributing the pressure loss from the slide-gate to the entire nozzle through increased friction losses. Under negative pressure, a submillimeter-thin gap was shown to cause considerable air aspiration. Clogging shutdown times were evaluated for several scenarios under static and dynamic operating conditions.Keywords
Funding Information
- National Science Foundation (CMMI 18-08731)
- Continuous Casting Consortium at University of Illinois at Urbana-Champaign (NA)
This publication has 30 references indexed in Scilit:
- Modeling Argon Gas Behavior in Continuous Casting of SteelJOM, 2018
- Comparison of CFD Simulations with Experimental Measurements of Nozzle Clogging in Continuous Casting of SteelsMetallurgical and Materials Transactions B, 2016
- A Study of Cluster Characteristics in Liquid Stainless Steel and in a Clogged NozzleSteel Research International, 2015
- Modelling of Pressure Distribution inside the SEN in a Stopper‐rod controlled SystemSteel Research International, 2010
- Flow Transport and Inclusion Motion in Steel Continuous-Casting Mold under Submerged Entry Nozzle Clogging ConditionMetallurgical and Materials Transactions B, 2008
- Inclusion removal by bubble flotation in a continuous casting moldMetallurgical and Materials Transactions B, 2006
- Effects of clogging, argon injection, and continuous casting conditions on flow and air aspiration in submerged entry nozzlesMetallurgical and Materials Transactions B, 2001
- Prevention of Air Suction from the Contact-part between Sliding Gate and Immersion Nozzle.ISIJ International, 1998
- Quantitative evaluation of effects of non-metallic inclusions on fatigue strength of high strength steels. I: Basic fatigue mechanism and evaluation of correlation between the fatigue fracture stress and the size and location of non-metallic inclusionsInternational Journal of Fatigue, 1989
- The Influence of Inclusions on the Toughness and Fatigue Properties of A516-70 SteelJournal of Engineering Materials and Technology, 1979