A novel fabrication process of a silicon field emitter array with thermal oxide as a gate insulator
Authors:
- Sang Jik KwonSKSang Jik Kwon
- 1 November 1995
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 16 (11) , 488-490
Abstract
We have successfully developed a fabrication process of a silicon field emitter array with a gate insulator formed by Si 3 N 4 sidewall formation and subsequent thermal oxidation. This process overcomes some problems in the conventional fabrication, such as high etch rate, low breakdown field, and gate hole expansion arising from evaporation of gate oxide. Therefore, we could improve process stability and emission performance, and also reduce gate leakage current. The optimum process conditions were determined by process simulations using SUPREM-4. The turn-on voltage of the fabricated field emitters was approximately 38 V. An anode current of 0.1 μA (1 μA) per tip was measured for a 625-tip array at the gate bias of 80 V (100 V), and the gate current was less than 0.3% of the anode current at those emission levels.Keywords
This publication has 5 references indexed in Scilit:
- Simulation of field emission microtriodesIEEE Transactions on Electron Devices, 1993
- 200 nm gated field emittersIEEE Electron Device Letters, 1993
- Nanometer scale thin-film-edge emitter devices with high current density characteristics1992
- Oxidation-sharpened gated field emitter array processIEEE Transactions on Electron Devices, 1991
- Emission properties of Spindt-type cold cathodes with different emission cone materialIEEE Transactions on Electron Devices, 1991